Monitoring is an important component in pest management, to prevent or mitigate outbreaks of native pests and to check for quarantine organisms. Surveys often rely on trapping, especially when the target species respond to semiochemicals. Many traps are available for this purpose, but they are bulky in most cases, which raises transportation and deployment issues, and they are expensive, which limits the size and accuracy of any network. To overcome these difficulties, entomologists have used recycled material, such as modified plastic bottles, producing cheap and reliable traps but at the cost of recurrent handywork, not necessarily possible for all end-users (e.g., for national plant-protection organizations). These bottle-traps have allowed very large surveys to be conducted, which would have been impossible with standard commercial traps, and we illustrate this approach with a few examples. Here, we present, under a Creative Commons BY-SA License, the blueprint for a fan-trap, a foldable model, laser cut from a sheet of polypropylene, which can rapidly be produced in large numbers in a Fab lab or by a commercial company and could be transported and deployed in the field with very little effort. Our first field comparisons show that fan-traps are as efficient as bottle-traps for some Scolytinae species and we describe two cases where they are being used for monitoring.
The performances of traps used for pest monitoring are not well understood. Variable trap sizes and shapes make cross-comparisons difficult. We tested with four Scolytinae species (Coleoptera, Curculionidae) a set of traps of the same model (fan-traps) in four sizes (310, 536, 832.5, 1,200 cm2), and a larger trap with another design (a four-vane trap, 4,500 cm2). A significantly linear relationship was observed between trap sizes and catches for Pityogenes chalcographus, but the catches of Ips typographus, Trypodendron lineatum and T. signatum tapered off. In the literature, comparable tapering-off effects were observed with Xyleborus glabratus (Scolytinae) and Agrilus planipennis (Coleoptera, Buprestidae), but a significant linear response with increasing trap size was observed with Trypodendron lineatum and T. rufitarsus. In another test, beetle landing behaviour was measured on a 1 m2 glued panel baited with lineatin (the Trypodendron spp. pheromone) and ethanol (a host kairomone). The landing densities of Trypodendron spp. did not increase with the distance to the attractants whilst Anisandrus dispar landed in very significantly higher densities far from the attractants. Species using pheromones to locate mate and host appear to land closer to the source of attractants than species responding to kairomones for locating a suitable host.
Monitoring is an important component of pest management, to prevent or mitigate outbreaks of native pests, and to check for quarantine organisms. Surveys often rely on trapping, especially when the target species respond to semiochemicals. Many traps are available for this purpose, but they are bulky in most cases, which raises transportation and deployment issues, and they are expensive, which limits the size and accuracy of any network. To overpass these difficulties, entomologists have used recycled material, such as modified plastic bottles, producing cheap and reliable traps but at the cost of recurrent handywork, not necessarily possible for all end-users (e.g., for national plant protection organizations). These bottle-traps have allowed very large surveys which would have been impossible with standard commercial traps, and we illustrate this approach with a few examples. Here we present, under a Creative Commons BY-SA License, the blueprint of a fan-trap, a foldable model, laser-cut from a sheet of polypropylene, that can rapidly be produced in large numbers, and could be transported and deployed in the field with very little efforts. Our first field comparisons show that fan-traps are as efficient as bottle-traps, and we describe two cases where they are being used for monitoring.