Tropical country like Malaysia is rich with residual soil and nurtured with high rainfall amount on average 2,550 mm per year. From 2009 until 2018, there are many landslide events reported in the news at Ranau, Sabah and Canada Hill Miri, Sarawak that occurred during rainy season and the landslide recurs within same location over the years. The objective of this study is to determine the relationship of landslide events with geological condition and rainfall at Ranau, Sabah and Canada Hill Miri, Sarawak. Historical landslide data were obtained from local news, previous researchers, and local authorities. Integrated review was conducted to meet the objective. In summary, both areas are prone to landslide due to the high average amount rainfall recorded and the geological properties that are susceptible to landslide occurrence namely shale interbedded with sandstone. Sandstone and shale contact are easily accessible by water weaken the contact surface lead to landslides incidents. Besides, Shale classified as highly plastic soil due to high amount of clay. Clay soil depends on its matric suction to sustain its strength towards sliding. Thus, increasing of pore pressure from rain infiltration reduce the matric suction and eventually reduce the shear strength. Ranau is located at seismically active area compare to Miri and other locations in Sabah crossing Lobou-Lobou fault, Mensaban fault and Mesilou fault. Theoretically, slope instability due to earthquake happened because the cementation of soil may be broken and lead to lesser roughness between soil surfaces resulting in reduction of internal friction angle and cohesion of soil. HIGHLIGHTS Rainfall-induced landslides are the common landslides phenomenon worldwide including East Malaysia. However, due to the high number of seismic activity, Earthquake-induced landslides should not be neglected as one of slope failure phenomena in East Malaysia Combinations of both Rainfall and Earthquake are required to be investigated due to the presence of both landslide triggering factors from historical data at East Malaysia GRAPHICAL ABSTRACT
1 April 2020 in IOP Conference Series: Earth and Environmental Science
Sabah has witnessed an increasingly low to moderate number of seismic activities throughout the years due to active Mensaban and Lobou-Lobou faults lines. Vulnerability level of older buildings in Sabah, designed and built on the basis of older codes of practice poses a significant threat to life safety and structural capacities of the existing buildings. This paper presents a framework of preliminary seismic vulnerability assessment of existing buildings in Kota Kinabalu. Building stocks include major government buildings and facilities, residential, educational, institutional, business as well as public buildings. The objective of this study is to evaluate and determine the vulnerability of existing buildings in seven major areas near Kota Kinabalu district using Rapid Visual Screening (RVS) scoring method based on FEMA154 (2002). The rapid visual score indicates that from the total two-hundredth-fifty (250) buildings assessed, (60.4%) are categorized as unsafe buildings and are strongly recommended for further evaluation and detailed analysis whereby modelling of structure is necessary.
This paper presents the significance of a seismic hazard curve plot as a dynamic parameter in estimating earthquake-resistant structures. Various cases of structural damages in Malaysia are due to underestimating earthquake loadings since mostly buildings were designed without seismic loads. Sabah is classified as having low to moderate seismic activity due to a few active fault lines. Background point, area, and line sources are the three tectonic features that have impacted Sabah. Data on earthquakes from 1900 to 2021 have been collected by a number of earthquake data centers. The seismicity is based on a list of historical seismicities in the area, which stretches from latitudes 4 °S to 8 °N and longitudes 115 °E to 120 °E. The goal of this research is to develop a seismic hazard curve based on a conventional probabilistic seismic hazard analysis being examined for the maximum peak ground acceleration at 10% probability of exceedance as published in MSEN1998-1:2015. This study extended to 5% and 2% probability of exceedance combined with the seismic hazard curve by using Ranau as a case study. To calculate the expected ground motion recurrence, such as peak ground acceleration at the site, earthquake recurrence models were combined with selected ground motion models. A logic tree structure was used to combine simple quantities such as maximum magnitudes and the chosen ground motion models to describe epistemic uncertainty. The result demonstrates that peak ground acceleration values at the bedrock were estimated to be 0.16, 0.21, and 0.28 g of the total seismic hazard curve at 10%, 5%, and 2% PE in a 50-year return period, respectively. The seismic hazard study at a Ranau site basically depends on the seismicity of a region and the consequences of failure in the past. Thus, the results can be used as a basis for benchmarking design or evaluation decisions and for designing remedial measures for Sabah constructions to minimize structural failure.
1 September 2021 in Civil Engineering and Architecture
A gradual increase in moderate and low seismic activity has occurred in Sabah over the course of several years due to the presence of certain moderately active fault lines in the region. Around 300 moderate earthquakes with magnitudes ranging from MW 4.0 to 7.0 have occurred in the last 120 years. The majority of existing buildings in Sabah are wind and gravity loaded. This study proposes a preliminary seismic vulnerability assessment methodology based on empirical and analytical vulnerability method for 250 existing buildings in Kota Kinabalu city. The empirical vulnerability assessment focuses on building evaluation utilizing a standard Rapid Visual Screening (RVS) method and the FEMA 154 guidebook's moderate seismicity assessment form. A field survey was conducted on the buildings ranging in height from low-rise to high-rise. As a result, when subjected to moderate-intensity earthquakes, 60% of the buildings are classed as susceptible and vulnerable to seismic hazard. The current study included the use of nonlinear static analysis to seven different building cases for further investigation. The findings of the analysis demonstrate that the majority of the buildings respond linearly elastical when subjected to peak ground acceleration (PGA) at 0.17g, which indicate that, buildings without seismic design accumulate damage early when subjected to moderate earthquake loadings.
The earthquake may cause many deaths and injuries and extensive property damage and dramatically change the geographic structure of the impacted area. Vulnerability in the context of building structure can be defined as inability to resist the earthquake loadings and unfortunately the majority of existing buildings in Ranau Township were built consequently without seismic consideration. The rapid development had increased the probability of building damages due to the earthquake activities that appeared around the area since. This study aims to identify, evaluate buildings and calculated vulnerability using the Rapid Visual Screening (RVS) method through the framework of Geographic Information System (GIS). The results of this study revealed that from 245 buildings, the damage level for 21 buildings were in grade 3, 11 buildings under grade 2 and other buildings in grade 1 i.e. heavy, moderate and little damages, respectively. After knowing the vulnerability level of buildings, the developer may do an early prevention to avoid further damages due to earthquakes in the future. This method can be used in moderate seismicity region such as Sabah as an early detection for building vulnerabilities.