It is of great significance in the field of engineering to repair the surface defects of ZM6 cast magnesium alloy by an arc welding method. Compared with the traditional tungsten inert gas (TIG) welding repair technology, cold metal transfer (CMT) welding repair has the advantages of low heat input, small repair deformation, and high efficiency. It is of great research value to repair the surface defects of ZM6 cast magnesium alloy by CMT welding. In this paper, the effect of CMT welding repair parameters on defect repair forming is systematically studied, and a repair process window free of unfused defects is obtained. The effects of preheating temperature of base material, wire-feeding speed, welding speed, stick-out length of welding wire and shielding gas flow on the spread of magnesium alloy melt and weld formation were investigated by a surface surfacing method. During the welding process, a camera was used to capture images of the arc and droplet features. A pit defect with a depth of 11.5 mm was machined on the surface of the casting, and the effect of five different repair paths on the formation of the repair area was studied. In order to make the repair area have better fusion, reasonable repair parameters are as follows: The preheating temperature range is 310–450 °C, the wire-feeding speed range is 5–7 m/min, the welding speed range is 8–10 mm/s, the stick-out length of the welding wire is 12 mm, the shielding gas flow rate is 20 L/min, and the repair path adopts a continuous linear reciprocating welding path. This study has important significance for guiding the development of CMT repair technology of cast magnesium alloy.

The study focuses on investigating the relationship between the ultrasonic effect and microstructure of ultrasonic-assisted gas tungsten arc welding (UA-GTAW) Inconel690 alloy joints. The influence of ultrasonic vibrations on Inconel690 plates was examined, while also clarifying the distribution pattern of the ultrasonic effect across the plate. Furthermore, actual welding experiments were performed by varying the distance between the ultrasonic horn and the welding torch. The results revealed that there were changes in both grain growth direction within the weld zone and refinement effects achieved under different distances. The optimal refinement of primary and secondary dendrite arm spacing was observed at distances of 60 mm and 180 mm between the welding torch and ultrasonic horn. The hardness of weld zone reached 235HV₁ when the distance between ultrasonic horn and welding torch is 180 mm.

Double-wire arc welding involves simultaneously feeding two wires into a molten pool, improving the efficiency and flexibility of traditional welding techniques. However, the interactions between the two wires and the molten pools are complex, which increases the difficulties in process and composition control. This work focuses on the weld pool flow characteristics in double-wire TIG arc welding. A CFD model incorporating a liquid bridge transfer model was developed to simulate the fluid flow phenomenon. Results show that the bead-forming appearances and flow characteristics of double-wire arc welding show no significant differences from single-wire arc welding. Welding current and welding speed have significant effects on the weld bead dimensions, while only welding current has effects on the flow characteristics. Wire feed XOZ angles show no significant influences on weld bead forming appearances and molten pool flow characteristics. Wire feed XOY angles influence the symmetry of the weld bead and the fluid flow. In 5B71/7055 heterogeneous double-wire arc welding, achieving a uniform distribution of alloy elements is difficult due to the complex convection patterns within the molten pool.