Under the single-loop structure, the problem of overcurrent protection for permanent magnet synchronous motor (PMSM) is investigated in this paper. Due to the combination of speed loop and current loop, the q-axis current become a state of PMSM control system, instead of the output of current loop in the cascade control. As a consequence, the conventional controllers can not restrict the q-axis current into a safe zone. But an oversize transient current may lead to damage of hardwares and property loss. To this end, a new current-constrained controller is proposed to deal with the issue of over-current protection. Different from previous methods of state constraints, the effects of disturbance is taken into account of controller design. A reduced-order generalized proportional integral observer (RGPIO) is adopted to estimate the uncertainties and disturbances. Our method can be considered as a composition of current-constrained control plus feed-forward compensation based on RGPIO. A rigorous stability analysis for the closed-loop system is presented. Compared with the conventional PID controller, the proposed method not only limits q-axis current to a safe range, but also has a good anti-disturbance ability. The feasibility and efficiency of the proposed method is validated by both simulation and experimental results.
14 July 2021 in IEEE Transactions on Intelligent Transportation Systems
For the purpose of avoiding injury and realizing precise operations, the multilateral teleoperation system is the most efficient way to transport trace toxic or radioactive substances, to perform minimally invasive surgery, etc. It is essential to enhance the transparency of a multilateral teleoperation system including multiple masters and the single slave manipulator. However, there are few researchers focus on the allocation of the contact force of the single slave manipulator to different master manipulators. In this paper, we firstly introduce the concept of force translation for teleoperation systems consisting of dual hand master (left and right hands) manipulators and a single slave manipulator. Force translation reflects how the impedance on the single slave side is translated or allocated to contact forces on different master sides. To maintain the stability of the system and to improve transparency, we elucidate the mechanism of the force translation and analyze the relation among masters and the slave. Furthermore, the force translation mechanism is analyzed through numerical simulations and CHAI 3D virtual physical simulations. It is used to propose a multilateral impedance control, and the Lyapunov function is used to analyze the system stability. The results of numerical simulations and real robot experiments verify the effectiveness of the proposed control methods based on the proposed force translation mechanism.
21 September 2017 in Transactions of the Institute of Measurement and Control
With the development of digital signal processes, the relative differences of PMSM single loop in control periods between the speed loop and current loops are becoming smaller or even vanishing. Therefore, cascade control schemes seem to be unnecessary. In addition, considering the effects of disturbances and the variety of moments of inertia, this paper proposes a scheme using an adaptive non-cascade control method to design the controller, which merges speed loop and q-axis current loop into one single loop. First, an extended state observer (ESO) is employed to estimate the disturbances of the system. The estimated value is used in the feedforward compensation design to improve the capability of system anti-disturbance. Then, considering the performance degradation caused by inertia change, an adaptive control scheme is developed. By using inertia identification technology, the feedforward compensation gain can be tuned automatically according to the identification value. Several groups of simulations and experiments are carried out and the results demonstrate the effectiveness of the proposed scheme.
Aiming at the nonlinear and multiple disturbances in the multi-quadcopter UAV system, this paper proposes a leader–follower composite formation control strategy based on an improved super-twisted sliding mode controller (ISTSMC) and a finite-time extended state observer (FTESO). For the designed sliding mode control algorithm, the integral term’s switching function is replaced with a non-smooth term to reduce the vibration in the control, further improving the overall performance of the system. For external disturbances, the finite-time extended state observer achieves rapid and accurate observation of external disturbances. Finally, through formation control experiments, the reliability and superiority of the proposed composite formation controller (CFC) is validated.