Interrupted sampling repeater jamming (ISRJ) is a classic active coherent jamming. Due to its structural limitations, it has inherent defects such as a discontinuous time–frequency (TF) distribution, strong distribution regularity of pulse compression results, limited jamming amplitude, and strong false targets lagging behind the real target. These defects have not been fully resolved yet due to the limitation of the theoretical analysis system. Based on the analysis of the influence factors of ISRJ on the interference performance for linear-frequency-modulated (LFM) and phase-coded signals, this paper proposes an improved ISRJ method based on the joint subsection frequency shift and two-phase modulation. The coherent superposition of jamming signals at different positions for LFM signals is achieved by controlling the frequency shift matrix and the phase modulation parameters to form a strong pre-lead false target or multiple positions and ranges of blanket jamming areas. For the phase-coded signal, the pre-lead false targets are generated through code prediction and the two-phase modulation of the code sequence, resulting in similar noise interference. The simulation results show that this method can overcome the inherent defects of ISRJ.

The existence of multiple self-interference (SI) signal components, particularly the nonlinear ones, seriously constrains the performance of self-interference cancellation (SIC) methods. To decrease the complexity of SIC methods in full-duplex devices, this article proposes a power analysis method for SI signal components in a full-duplex transceiver. The proposed method comprises a separate analysis algorithm and a system-level power model. Initially, the algorithm is conducted to obtain the spectrum of the linear and nonlinear components in the power amplifier (PA) output signal. Once the linear-to-nonlinear power ratio (LNPR) has been obtained, a system-level power model is constructed by taking both the transmitter noise and analog-to-digital converter (ADC) quantization noise into account. The proposed power model allows for the allocation of SIC method performance in multiple domains during the design of full-duplex transceivers at the top level, thereby reducing the overall system complexity. The simulation results demonstrate that in a full-duplex transceiver with only antenna isolation, the power of the SI signal component is susceptible to alterations due to the operating waveform and transmission power. Finally, the accuracy of the power analysis method is verified through measurement and Simulink.