Perovskite solar cells (PSCs) have substantially increased their power conversion efficiency (PCE) to more than 25% in recent years. However, the instability of these devices is still a strong obstacle for their commercial applications. Recently, all-inorganic PSCs based on CsPbI₃ and CsPbI₂Br as the perovskite layer have shown enhanced long-term stability, which makes them potential candidates for commercialization. Currently, all-inorganic PSCs with inverted p-i-n configuration have not yet reached the high efficiency achieved in the normal n-i-p structure. However, the inverted p-i-n architecture has recently drawn attention of researchers because it is more suitable to prepare tandem solar cells. In this work, a theoretical study of inverted p-i-n all-inorganic PSCs based on CsPbI₃ and CsPbI₂Br as the perovskite layer was carried out using SCAPS-1D software (ver. 3.3.09). The performance of different architectures of PSC was examined and compared by means of numerical simulations using various inorganic materials as the hole transport layer (HTL) and the electron transport layer (ETL). The results reveal that CuI and ZnO are the most suitable as HTL and ETL, respectively. In addition, the performance of the devices was significantly improved by optimizing the hole mobility in CuI as well as the thickness, doping density, and defect density in the absorber layer. Maximum efficiencies of 26.5% and 20.6% were obtained under optimized conditions for the inverted all-inorganic CsPbI₃- and CsPbI₂Br-based PSCs, respectively. These results indicate that further improvements in the performance of such devices are still possible.

The investigation of scintillation properties of europium doped yttrium orthovanadate shows the suitability of this material for fiber-based dose rate measurements. All measurements were carried out with a 6 MV Varian linear accelerator. The temperature dependence of the signal is lower than that of the plastic scintillators reported so far. By measuring the afterglow of probes between Linac-pulses, the signal due to the stem effect can be successfully eliminated. Comparison of depth dose profiles in a water phantom for radiation field dimensions between 1 x 1 cm(2) and 10 x 10 cm(2) shows that the probes are suitable for small fields having dimensions up to 1 x 1 cm(2). The high light yield of probes having dimensions of 1 mm opens up the possibility for their use in spatially confined radiation fields, such as in intensity-modulated radiotherapy (IMRT) and volume-modulated radiation therapy (VMAT).

All-inorganic perovskite solar cells (PSCs) with inverted p-i-n configuration have not yet reached the high efficiency achieved in the normal n-i-p architecture. However, the inverted all-inorganic PSC are more compatible with the fabrication of tandem solar cells. In this work, a theoretical study of all-inorganic PSCs with inverted structure ITO/HTL/CsPbIxBr3−x/ETL/Ag, has been performed by means of computer simulation. Four p‐type inorganic materials (NiO, Cu2O, CuSCN and CuI) and three n-type inorganic materials (ZnO, TiO2 and SnO2) were used as hole and electron transport layers (HTL and ETL), respectively. A band gap of 1.78 eV was used for the CsPbI x Br3−x perovskite layer. The simulation results allow identifying that CuI and ZnO are the most appropriate materials as HTL and ETL, respectively. Additionally, optimized values of thickness, acceptor density and defect density in the absorber layer have been obtained for the ITO/CuI/CsPbI x Br3−x /ZnO/Ag, from which, an optimum efficiency of 21.82% was achieved. These promising theoretical results aim to improve the manufacturing process of inverted all-inorganic PSCs and to enhance the performance of perovskite–perovskite tandem solar cells.