This paper investigates techniques for N-type high-resistance polysilicon resistors to reduce the resistance deviation which is caused by the back-end mechanical stress. In the back-end layers of the wafer, a top metal thickness equal to $3~\mu \text{m}$ is provided to increase the heat allowing current density in the metal routes of power ICs. The top metal processing yields the mechanical stress to increase the resistance by the piezoresistance effect. To eliminate the mechanical stresses, a new layout is proposed with the full passivation cutting (FPC). The resistor with an FPC uses the passivation film separation to create a physical empty room for suppressing the mechanical stresses on the polysilicon. The proposed layout has been verified in the 0.4- $\mu \text{m}$ bipolar-CMOS-DMOS process, and the resistance shifts were compared with other four-type layouts. Compared to those original layouts, the proposed layout exhibits the improvements in the resistance deviation reduction in the maximum ratio 20.80%.
A multi-functional cardiac signal processor (CSP) with integrated sensor interfaces is designed for mobile healthcare applications, especially for heart activity diagnosis in different phases. Applying dedicated processing engines, the CSP extracts critical cardiac signal features based on compressed data with 90% storage reduction, while keeping the data network secure. Implemented in 90nm CMOS, the CSP consumes 22.6μW to 46.5μW at 0.5/1.0V in different configurations. Besides, the 10.2μW biopotential and 11.4μW capacitive sensor interfaces further enhance the system functionality.
30 May 2018 in IEEE Transactions on Electron Devices
The safe-operating-area (SOA) of large array device (LAD) is one of the most important factors affecting the device reliability. In this paper, the improvement of the electrical-SOA (E-SOA) and the thermal-SOA (T-SOA) by using an optional implantation layer for 5-V n-channel large array MOSFET has been investigated in a 0.15-μm bipolar-CMOS-DMOS process. Experimental results showed that the secondary breakdown current (It2) is improved by 5 times, and a significant improvement is also observed in the E-SOA and the T-SOA boundary as compared to the original device. In addition, the impact of inserting additional layout pick-ups into the multiple-finger layout of large array MOSFET to the E-SOA, It2, and trigger voltage is also practically investigated in silicon for the LAD with a total width of 12,000 μm.
This paper presents an integrated transciver chip for use in electro-static coupling intra body communication. A simplified circuit model was developed to analyze the channel characteristics. A Manchester code was used to increase signal energy. In front of the receiver, an inverter-based amplifier applies to amplify the received data. Then, a Clock and Data Recovery data develops to recover the transmitted data. The chip is fabricated using UMC 0.18um CMOS process with a chip area of 0.75 × 0.7 mm2, power consumption of 22uW and a data transmission rate of 10M bit per second.
This paper presents a method of thermal balancing for monolithic power integrated circuits (ICs). An on-chip temperature monitoring sensor that consists of a poly resistor strip in each of multiple parallel MOSFET banks is developed. A temperature-to-frequency converter (TFC) is proposed to quantize on-chip temperature. A pulse-width-modulation (PWM) methodology is developed to balance the channel temperature based on the quantization. The modulated PWM pulses control the hottest of metal-oxide-semiconductor field-effect transistor (MOSFET) bank to reduce its power dissipation and heat generation. A test chip with eight parallel MOSFET banks is fabricated in TSMC 0.25 μm HV BCD processes, and total area is 900 × 914 μm2. The maximal temperature variation among the eight banks can reduce to 2.8 °C by the proposed thermal balancing system from 9.5 °C with 1.5 W dissipation. As a result, our proposed system improves the lifetime of a power MOSFET by 20%.