One of the most often used approaches for approximating various matrix equation problems is the hyperpower family of iterative methods with arbitrary convergence order, whereas the zeroing neural network (ZNN) is a type of neural dynamics intended for handling time-varying problems. A family of ZNN models that correlate with the hyperpower iterative methods is defined on the basis of the analogy that was discovered. These models, known as higher-order ZNN models (HOZNN), can be used to find real symmetric solutions of time-varying algebraic Riccati equations. Furthermore, a noise-handling HOZNN (NHOZNN) class of dynamical systems is introduced. The traditional ZNN and HOZNN dynamic flows are compared theoretically and numerically.
A Wearable Robotic Knee (WRK) is a mobile device designed to assist disabled individuals in moving freely in undefined environments without external support. An advanced controller is required to track the output trajectory of a WRK device in order to resolve uncertainties that are caused by modeling errors and external disturbances. During the performance of a task, disturbances are caused by changes in the external load and dynamic work conditions, such as by holding weights while performing the task. The aim of this study is to address these issues and enhance the performance of the output trajectory tracking goal using an adaptive robust controller based on the Radial Basis Function (RBF) Neural Network (NN) system and Hamilton–Jacobi Inequality (HJI) approach. WRK dynamics are established using the Lagrange approach at the outset of the analysis. Afterwards, the gain technique is applied to enhance the control motion solutions and provide the main features of the designed WRK control systems. To prove the stability of the controlled system, the HJI approach is investigated next using optimization techniques. The synthesized RBF NN algorithm supports the easy implementation of the adaptive controller, as well as ensuring the stability of the WRK system. An analysis of the numerical simulation results is performed in order to demonstrate the robustness and effectiveness of the proposed tracking control algorithm. The results showed the ability of the suggested controller of this study to find a solution to uncertainties.
Effects of sequential velocity and variable magnetic field on the phase change during hybrid nanofluid convection through a 3D cylinder containing a phase-change material packed bed (PCM-PB) system is analyzed with the finite element method. As the heat transfer fluid, 40% ethylene glycol with hybrid TiO-AlO nanoparticles is considered. Impacts of the sequential velocity parameter (K, between 0.5 and 1.5), geometric factor of the conic-shaped PCM-PB (M, between 0.2 and 0.9), magnetic field strength (Ha number between 0 and 50) and solid volume fraction of hybrid nanoparticles (vol.% between and ) on the phase change dynamics are explored. Effects of both constant and varying magnetic fields on the phase change process were considered. Due to the increased fluid velocity at the walls, the phase change becomes higher with higher values of the sequential velocity parameter (K). There is a 21.6% reduction in phase transition time (tF) between the smallest and highest values of K both in the absence and presence of a constant magnetic field. The value of tF is reduced with higher magnetic field strength and the amount of reduction depends upon the sequential velocity parameter. At K = 1.5, the reduction amount with the highest Ha number is 14.7%, while it is 26% at K = 0.5. When nanoparticle is loaded in the base fluid, the value of tF is further reduced. In the absence of a magnetic field, the amount of phase-transition time reduction is 6.9%, while at Ha = 50, it is 11.7%. The phase change process can be controlled with varying magnetic field parameters as well. As the wave number and amplitude of the varying magnetic field are considered, significant changes in the tF are observed.