Hongbin Rui

Dr. Hongbin Rui


Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 August 2021 in Coatings
Verified
Journal Article
Open access
PDF file
DZDongya Zhang
Dongya Zhang
ZLZhongwei Li
Zhongwei Li
HFHongwei Fan
Hongwei Fan
HRHongbin Rui
Hongbin Rui
WJWeitao Jia
Weitao Jia
In this study, a cladding layer and nitriding layer were prepared on nodular cast iron, to provide guidance for remanufacturing of nodular cast iron. Their microstructure and composition and the tribological properties under dry and starved lubrication conditions were studied. Meanwhile, the contact stresses at different friction stages were simulated through the finite element method. The micro-hardness of the cladding layer and nitriding layer were 694 HV0.5 and 724.5 HV0.5, which were 4 times and 4.2 times higher than that of the substrate. For dry friction conditions, the wear resistance of the cladding layer and nitriding layer were 113.2 times and 65.5 times that of the substrate. For starved lubrication conditions, the friction coefficients of the cladding layer and nitriding layer were lower than that of the substrate. In addition, their average friction coefficients and wear resistance were gradually reduced with the increase in load. Contact simulation showed that the maximum equivalent stress gradually increased with the friction coefficient during the dry friction, and the peak value of von Mises stress on the nitriding layer was larger than that of the cladding layer, and the nitriding layer was more likely to yield and peel off.

29 November 2024 in Coatings
Verified
Journal Article
Open access
PDF file
HYHongbin Yang
Hongbin Yang
SDSensen Du
Sensen Du
YLYanhe Li
Yanhe Li
YZYe Zhang
Ye Zhang
HRHongbin Rui
Hongbin Rui
DZDongya Zhang
Dongya Zhang
In this study, a comprehensive regeneration process was employed to enhance the recycling efficiency and performance of waste gear oil. The process began with the waste gear oil subjected to extraction flocculation, which was then followed by vacuum distillation for solvent removal. Then, catalytic hydrogenation was performed, and HiTEC 3339 additive was incorporated at concentrations that ranged from 0.25% to 1.5%, thus resulting in the regenerated gear oil. The tribological properties of the regenerated gear oil were investigated under various load conditions using a friction and wear testing apparatus. When a load of 10 N was applied, the filtered oil (Oil 2) exhibited an average friction coefficient of 0.092 and a volumetric wear rate of 8.25 × 10−8 mm3/Nm, which represented reductions of 8.23% and 42.7%, respectively, when compared to the unfiltered oil (Oil 1). As the load was increased to 50 N, Oil 2 demonstrated a wear rate of 23.4 × 10−8 mm3/Nm, indicating a 20.9% improvement in wear resistance. As the concentration of the additive increased, the following trends were observed: (i) Under a load of 10 N, the friction coefficients demonstrated a gradual decreasing trend, while at 50 N, the friction coefficients were remarkably similar and significantly lower than those at 10 N. (ii) The wear rates initially decreased and then increased. Among the tested lubricants, Oil 4 (containing 0.5% HiTEC 3339) exhibited the shallowest wear scar depth under various loads, which indicated superior anti-wear performance. When Oil 4 was thoroughly evaluated through bench tests, it indicated excellent extreme pressure and anti-wear properties, as well as superior rust and corrosion prevention capabilities and high–low temperature performance. The overall performance indicators of Oil 4 were discovered to be similar to those of fresh oil.