Jun Xie

Dr. Jun Xie

School of Mechanical Engineering, Zhejiang University, Hangzhou, China

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 June 2021 in Nanomaterials
Verified
Journal Article
Open access
PDF file
CLChenxin Lyu
Chenxin Lyu
Peng ZhaoPeng Zhao
Peng Zhao
Jun XieJun Xie
Jun Xie
SDShuyuan Dong
Shuyuan Dong
JLJiawei Liu
Jiawei Liu
Jianzhong FuJianzhong Fu
Jianzhong Fu
Air pollution caused by particulate matter and toxic gases is violating individual’s health and safety. Nanofibrous membrane, being a reliable filter medium for particulate matter, has been extensively studied and applied in the field of air purification. Among the different fabrication approaches of nanofibrous membrane, electrospinning is considered as the most favorable and effective due to its advantages of controllable process, high production efficiency, and low cost. The electrospun membranes, made of different materials and unique structures, exhibit good PM2.5 filtration performance and multi-functions, and are used as masks and filters against PM2.5. This review presents a brief overview of electrospinning techniques, different structures of electrospun nanofibrous membranes, unique characteristics and functions of the fabricated membranes, and summarization of the outdoor and indoor applications in PM filtration.

17 July 2021 in Polymers
Verified
Journal Article
Open access
PDF file
RGRuoxiang Gao
Ruoxiang Gao
Jun XieJun Xie
Jun Xie
JYJinghui Yang
Jinghui Yang
CZChaojie Zhuo
Chaojie Zhuo
Jianzhong FuJianzhong Fu
Jianzhong Fu
Peng ZhaoPeng Zhao
Peng Zhao
As a special engineering polymer, polyether ether ketone (PEEK) has been used widely due to its excellent mechanical properties, high thermal stability, and chemical resistance. Fused deposition modeling (FDM) is a promising process for fabricating PEEK parts. However, due to the semi-crystalline property and high melting point of PEEK, determining appropriate process parameters is important to reduce warpage deformation and improve the mechanical properties of PEEK. In this article, the influence of raster angle and infill density was determined by single factor experiment, which are the two most important parameters. The results showed that samples with 0°/90° raster angle and 50% infill density had the best comprehensive properties in terms of warpage deformation, tensile strength, and specific strength. Subsequently, based on the results above, the effects of printing speed, nozzle temperature, platform temperature, raster width, and layer thickness were analyzed by orthogonal experiment. The results indicated that platform temperature had the greatest impact on warpage deformation while printing speed and nozzle temperature were significant parameters on tensile strength. Through optimization, warpage deformation of the samples could be reduced to almost 0 and tensile strength could increase by 19.6% (from 40.56 to 48.50 MPa). This will support the development of FDM for PEEK.