Additive manufacturing of composite materials is progressing in the world of 3D printing technologies; composite materials allow the combination of the physical and mechanical properties of two or more constituents to create a new material that meets the required properties of several applications. In this research, the impact of adding Kevlar^® reinforcement rings on the tensile and flexural properties of the Onyx™ (nylon with carbon fibers) matrix was analyzed. Parameters such as infill type, infill density and fiber volume percentage were controlled to determine the mechanical response in tensile and flexural tests of the additive manufactured composites. The tested composites showed an increment of four times the tensile modulus and 1.4 times the flexural modulus of pure Onyx™ matrix when compared with that of the Onyx™–Kevlar^®. The experimental measurements demonstrated that Kevlar^® reinforcement rings can increase the tensile and flexural modulus of Onyx™–Kevlar^® composites using low fiber volume percentages (lower than 19% in both samples) and 50% of rectangular infill density. However, the appearance of some defects, such as delamination, was observed and should be further analyzed to obtain products that are errorless and can be reliable for real functions as in automotive or aeronautical industries.

Multilayer plastic films (MPFs) are widely used in the food industry. Despite its widespread use, the recycling of MPF remains a challenge due to its complex structure. Solvent-based recycling is more complex and costly than conventional mechanical recycling, which remains the most widely used method despite its technical and economic limitations. This study investigates the conventional mechanical recycling of post-consumer MPF without separating its constituent layers. Samples were prepared using a thermal extrusion cycle with the control of temperature, speed and sample size to improve the melt state, homogeneity and mechanical response of the mixture. The results of the physicomechanical characterization in this research study show that the proper selection of the extrusion parameters for a fine multilayer waste of 2 mm particle size, has a positive impact, for instance, on the final maximum strength of the recycled material, demonstrating an increase of up to 40 and 70% in tensile and flexural properties, respectively. The proposed mechanical recycling of post-consumer MPF without separation of its constituents can produce a material with mechanical properties comparable to those of low-density polyethylene and polypropylene. These findings could significantly benefit the recycling industry by reducing plastic pollution and allowing for creating new products with specific mechanical properties tailored for different applications.