Blood flow in the human vascular system is a complex to understand example of fluid dynamics in a closed conduit. Any irregularities in the hemodynamics may lead to lethal cardiovascular disease like heart attack, heart failure and ischemia. Numerical simulation of hemodynamics in the blood vessel can facilitate a thorough understanding of blood flow and its interaction with the adjacent vessel wall. A good simulation approach for blood flow can be helpful in early prediction and diagnosis of the mentioned disease. The simulation outcomes may also provide decision support for surgical planning and medical implants. This study reports an extensive review of various approaches adopted to analyze the influence of blood rheological characteristics in a different class of blood vessels. In particular, emphasis was given on the identification of best possible rheological model to effectively solve the hemodynamics inside different blood vessels. The performance capability of different rheological models was discussed for different classes and conditions of vessels and the best/poor performing models are listed out. The Carreau, Casson and generalized power-law models were appeared to be superior for solving the blood flow at all shear rates. In contrast, power law, Walburn-Scheck and Herchel-Bulkley model lacks behind in the purpose.
Erosion is a serious problem faced in many industries that includes the transport of sand and water slurry in slurry pipe line. This paper emphasizes on the investigation of erosion on a mild steel straight pipe at different parameters including fluid velocity, particle size and concentration. The fluid velocity is selected in the range of 2.5-10 m/s using computational fluid dynamics code ANSYS-CFX. Sand particle within the size range of 100-400 µm size and concentration 5%-15% are used in this study. An Euler-Lagrange approach is used to solve the multiphase flow phenomenon. A horizontal pipe of diameter 100 mm and length 1 m (10 times of diameter) is considered for the study. The stochastic model of Sommerfeld will be used to account the wall roughness of pipe. It is also observed that the erosion wear in the pipeline strongly depends on fluid velocity, particle size and concentration.
10 May 2018 in Journal of The Institution of Engineers (India): Series C
Particulate erosion is a major concern in slurry handling unit of a thermal power plant. The pipe bends are the most erosion affected element of a pipeline unit thus, a cost-effective method to reduce pipeline erosion is highly desirable. This work aims to suggest the optimal pipe bend design to minimize the particulate erosion by analyzing the erosion wear in geometrically different pipe bends for bottom ash slurry flow by using Computational Fluid Dynamics code FLUENT. A Three-dimensional simulation study of erosion wear is carried out by implementing Euler-Lagrange modeling along with the standard k-ε turbulence model to solve the complex multi-phase flow. Pipe bends of different bending angle (30°, 45°, 60°, and 90°), diameter (50 to 250 mm) and bending ratio (r/D = 1 to 2.5) are evaluated at different flow condition. The wear location gets shifted to the upper section of the bend and its magnitude is significantly reduced with the increase in pipe diameter and bending angle. The dynamics of multiphase slurry through different bends is analyzed to understand the complex wear phenomenon. The simulation result shows good agreement with the published findings. Finally, a least erosion affected pipe bend profile is suggested for slurry transport unit.