A numerical analysis method of trailing edge deboning is proposed in this paper. Using this method, multiple repair parameters can be quantified by analyzing aerodynamic responses and structural characteristics of the trailing edge. This method can be applied to three types of trailing edge, including blunt trailing edge, transitional trailing edge, and pointed trailing edge. In this study, the repair parameters are divided into two types, including the internal parameters that can affect the bonding strength and the external parameters that can affect the stiffness and aerodynamic shape. The main research steps are as follows: First, a repair structure shell‐body model was developed. Second, static tensile tests were carried out using 49 specimens, covering two lap joint types and seven bonding thicknesses. Finally, nine different repaired trailing edge models were developed using Ansys/Fluent for each two two‐dimensional airfoil. A 30–40 m section of a 71 m blade was used to develop a three‐dimensional (3D) rotating model with the repaired trailing edge. The simulation results show that the two internal parameters, overlap length and the slope of adhesive joints, are the key to improving the bonding performance of the pointed trailing edge. In addition, the bonding thickness range of 1–10 mm is proved by the experiment results and numerical analysis to be sufficient for good bonding performance. Besides this, the influence of the repair height on the aerodynamic pressure distribution and lift coefficient is much greater than the repair width, and the torque and power of the repaired 3D blade model are 1.91% higher than that of the original blade. This should further help provide an effective theoretical basis for determining the repair plan for a wind turbine blade.
The influence of the outer reinforcement layers on the repair structure and aerodynamic performance was studied. Firstly, a continuous damage mechanics model was established, and the 3D Hashin criterion and cohesive zone material model were used to analyze the damage repair model. The failure load deviation was 5.5%. Secondly, on the basis of the transition model and SST–ω turbulence model, the aerodynamic analysis model of DU300 airfoil was established. The numerical simulation results showed that the lift coefficient and pressure distribution at the angle of attack of 10° and 15° were deviated from the experimental values by 2%. Furthermore, 27 structural repair models, nine 2D aerodynamic repair models, and a 3D full-scale blade model were designed. It was found that, when the repair length accounted for 60% of the total model length, the failure load increased by 22%, but the aerodynamic power with the repair length of 10 m was decreased by 0.137%. When the repair area was large and the repair height was from 4 mm to 6 mm, the failure load was greatly increased by about 30%, and the aerodynamic pressure distribution and static pressure field fluctuated significantly. The results show that the structural and aerodynamic characteristics were closely related to the repair parameters.
Delamination damage to spar caps seriously endangers the operation safety of offshore wind turbines. The effect of initial delamination of various depths and areas on the ultimate tensile load of laminates is studied based on experiments and numerical simulation, and an effective method for predicting the residual tensile strength of laminates with high thickness is proposed. Three groups of initial delamination specimens with different characteristics were fabricated, and static displacement tensile tests were carried out. An accurate three-dimensional numerical analysis model was established, and the results were in good agreement with the experimental values, with the overall error of the failure load being less than 6%. Furthermore, a numerical model for a 20-ply high-thickness spar cap laminate was established to predict the effect of delamination on tensile strength. The results showed that, for the same depth of initial delamination, the difference in delamination area had little influence on the tensile strength. The dangerous locations of delamination were at the shallow surface and at the ratio of 0.3–0.4 in the thickness direction, and the maximum decrease in tensile strength was 14.86%; meanwhile, it was found that delamination on the middle surface had no significant effect on tensile strength.
22 January 2025 in Mechanics of Advanced Materials and Structures