Due to the complexity of occlusal contact, force and trajectory tracking is a crucial problem for the chewing robots. A position-based impedance control is proposed to realize hybrid control of chewing force and chewing trajectory in this paper. To eliminate the steady-state error of the single impedance control in uncertain environment, a novel adaptive impedance control is proposed for chewing robots and its adaptive control law is induced using Lyapunov stability theory. Simulations are conducted to test the performances of force tracking with the single impedance control and the novel adaptive impedance control, respectively. The findings of the simulations clearly demonstrate that the proposed adaptive impedance control outperforms the conventional single impedance control in force tracking.
The lubrication state of a tripod sliding universal coupling (TSUC) in an automotive half-shaft is critically influenced by three operating parameters derived from real driving conditions: input torque, shaft rotational speed, and the angle between the intermediate and input shafts. Grease is modeled as an Ostwald power-law fluid, which provides a tractable rheological approximation under high-shear TSUC conditions where the plug-flow region is negligible. The computed results show that the load mainly controls the spatial extent of the contact: a higher load broadens the Hertzian zone, reduces the film thickness, and moves the minimum film thickness and the secondary pressure/temperature peaks downstream. In contrast, raising either the frequency or the amplitude increases the entrainment velocity, leading to a thicker film with virtually unchanged central pressure; the secondary pressure peak becomes considerably stronger, and all characteristic positions shift toward the inlet. For similar entrainment velocities, the amplitude produces a slightly larger secondary pressure peak than the frequency, which can be attributed to different durations of the high-velocity phase. The relative intensity of the secondary pressure peak increases with both speed-related parameters and becomes the governing factor for surface endurance at the upper limit of the examined range. In this study, the load, frequency, and amplitude are not treated as free mathematical parameters; instead, they are assigned values derived from actual half-shaft operating conditions (driving torque, vehicle speed, and shaft angle) and varied one at a time within a physically meaningful range. This approach of assigning physically meaningful values to parameters—rather than treating them as arbitrary mathematical variables—distinguishes the present work from previous grease TEHL studies of TSUCs.