We propose a simple single-shot spatiotemporal measurement technique called coherent modulation imaging for the spatio-spectrum (CMISS), which reconstructs the full three-dimensional high-resolution characteristics of ultrashort pulses based on frequency-space division and coherent modulation imaging. We demonstrated it experimentally by measuring the spatiotemporal amplitude and phase of a single pulse with a spatial resolution of 44 µm and a phase accuracy of 0.04 rad. CMISS has good potential for high-power ultrashort-pulse laser facilities and can measure even spatiotemporally complicated pulses with important applications.
A novel chromatic aberration pre-compensation scheme for ultrashort petawatt laser systems was proposed. The pre-compensation scheme consists of a convex lens, group of concave lenses, and a spherical reflector combined with a conventional vacuum chamber. It provides a versatile method to accurately compensate the chromatic aberration of an entire laser system via controlling the amount of propagation time delay (PTD) induced by the compensator without changing the input and output beam size. A compensator, tailored based on the proposed scheme, was designed and experimentally evaluated for the Shen-Guang-II 5PW (SG-II 5PW) laser system at Shanghai Institute of Optics and Fine Mechanics (SIOM). The experimental results verified that chromatic aberration in the laser system was almost fully compensated: the size of laser beam focused by an f/2.42 off-axis parabolic mirror (OAP) was reduced tremendously from 3218to about 44at full width at half maximum (FWHM). The proposed scheme provides the flexibility to accurately correct chromatic aberration in high-power laser systems within a wide dynamic range.
We present a high efficiency and ultra-broadband optical parametric chirped-pulse amplification (OPCPA) system fully based on yttrium calcium oxyborate (YCOB) crystals. The OPCPA properties of YCOB at 808 nm are studied for both high gain and saturated amplification. The non-collinear angle is finely tuned to study the variation of gain spectrum at a certain phase-matching angle of YCOB crystals. After amplification by four YCOB crystals, a total signal gain of 0.9×109 is obtained and the FWHM spectral bandwidth is still over 100 nm. An amplified signal pulse of 182 mJ is achieved with pump energy of 440 mJ in the saturated amplification stage and the conversion efficiency is about 40%. After a four-grating compressor, a pulse duration of 20 fs is measured by a second-order autocorrelator.
The optical aperture of ultrashort extreme intensity laser facilities, which reach 10 PW, will be beyond several hundred millimeters. DKDP is by now the only nonlinear crystal that can be grown to such diameter and used in the main optical parametric chirped-pulse amplification (OPCPA) amplifier of such a laser system. Here, at the signal wavelength of 808 nm for the first time, we experimentally present a broadband OPCPA system that consists of a pre-amplifier in BBO crystals and a main OPCPA amplifier in two 95% deuterated DKDP crystals. The final amplified spectrum bandwidth exceeds 50 nm, and a compressed pulse duration of 27 fs has been measured. The conversion efficiency of the main OPCPA amplifier reached 24%, and a net signal gain of 13 was obtained. For the high energy OPCPA amplifier, the influence due to partial absorption on the idler pulses in DKDP crystal is theoretically analyzed. The results indicate the potential utilization of high deuterated DKDP for the main OPCPA amplifiers in a multi-petawatt laser system at 808 nm wavelength.
The spatiotemporal plasma-lens filter proposed here enhances the temporal contrast of the ultrashort pulse laser by combining plasma optics and spatial filtering. Experimentally, the spatiotemporal plasma-lens filter has improved the temporal contrast by 2 orders of magnitude with 80% laser transmission efficiency under a 1 Hz repetitive laser operation. Not only were the pre-pulse and the pedestal cleaned out, but also the rising edge of the main pulse was sharpened.
The advent of spatiotemporal wave packets (STWPs), represented by spatiotemporal optical vortices (STOVs), has paved the way for the exploration in optics and photonics. To date, despite considerable efforts, a comprehensive and efficient practical means to characterize wave packets with such complex structures is still lacking. In this study, we introduced a method designed to achieve high-precision and high-throughput spatiotemporal wave packet measurements using a user-friendly setup. This method is based on a quadriwave lateral shearing interferometric wavefront sensor that utilizes wavelength division multiplexing, termed the “spatiotemporal wavefront sensor (STWFS).” Using this method, we have fabricated a compact prototype with 295×295 spatial pixels×36 wavelength channels of 0.5 nm spectral resolution in a single frame. This STWFS enabled single-shot self-referenced spatiotemporal three-dimensional (3D) optical field characterizations of STWPs with transverse orbital angular momenta L of 1 and 2 and obtained the dynamic visualization of the focused propagation of STOV pulses. Furthermore, the STWFS provides a 1.87 nm (0.95%) root mean square absolute accuracy for spatiotemporal phase reconstruction. The STWFS exhibits excellent comprehensive performance compared to existing 3D spatiotemporal metrology methods. As a spatiotemporal optical field characterization method, the STWFS can be applied to any type of ultra-short laser beam and offers ultrafast 3D diagnostics, contributing to spatiotemporal photonics and broader applications across different fields such as light–matter interactions and optical communications.