This paper proposes an innovative CO2 enrichment system for crop production under a controlled greenhouse environment by means of tetra-n-butylammonium bromide (TBAB) + CO2 semi-clathrate hydrate (SC). In this system, CO2 is captured directly from exhaust gas from a combustion heater at night, which can be used for stimulating photosynthesis of crops in greenhouses during daytime. Although the gas capacity of TBAB + CO2 SC is less than that of CO2 gas hydrate, it is shown that TBAB + CO2 SC can store CO2 for CO2 enrichment in crop production even under moderate pressure conditions (<1.0 MPa) at 283 K.
1 May 2011 in Journal of Magnetism and Magnetic Materials
Climate change caused by global warming has become a serious issue in recent years. The main purpose of this study was to evaluate the effectiveness of the above system to quantitatively supply CO2 or CO2 hydrate from industrial to agricultural areas. In this analysis, several transportation methods, namely, truck, hydrate tank lorry, and pipeline, were considered. According to this analysis, the total CO2 supply costs including transportation ranged from 15 to 25 yen/kg-CO2 when the transportation distance was 50 km or less. The cost of the hydrate-based method increased with the transport distance in contrast to the liquefied CO2 approach. However, the technology of supplying CO2 hydrate had merit by using a local cooling technique for cooling specific parts of agricultural products.
Seafloor hydrothermal deposits, which were formed by deposition of precipitates from hydrothermal fluids vented from seafloor, are one of unconventional mineral resources beneath deep seafloors in the Exclusive Economic Zone of Japan. The authors have proposed a concept for Mineral Processing of Seafloor, where useful minerals are separated on deep seafloor and then lifted while remaining gangue is disposed on seafloor in appropriate ways. In this paper the authors studied the new ball milling system which was adapted under seafloor mineral processing. A simulator for ball mill grinding using simple discrete element method was built for this analysis. In this simulation two conditions in ball milling were examined: the method of grinding by enclosing the inside of a ball mill with air and with sea water. Especially we discussed the implementability of the ball mill grinding fulfilled with water because of the ease of installation in the real operation. Consequently, it was suggested that the grinding phenomenon can be performed effectively by the increase in the existence ratio of iron ball in the first quadrant in the mill. In the case where the mill is filled up with the water, it can be expected that crushing efficiency increases by carrying out ball milling at high rotational rate and with the mixture of the small ball size.
The aim of this study is to propose an agro-industrial heat transport system from industrial to agricultural areas for horticultural facilities with high heat demand to fill the problematic gap in the current heat transport system, and to derive by simulation the conditions under which this system can be used economically as well as environmentally. In this study, HASClay was used as a high-performance medium. HASClay has the ability to supply carbon dioxide (CO2) at the same time as heat and dehumidify the inside of the house, so it can be expected to increase the yield in addition to reducing the environmental load by using heat. The simulation results show that the proposed system of supplying heat to a large greenhouse in HASClay in 20-ton containers would have an economic budget similar to that of the previous system, but with an environmental impact of about 80% less tomatoes and 84% less chrysanthemum fuel than the previous system of heating with fuel oil. On the other hand, the analysis showed that the power of the fan could be reduced as an improvement of the heat transport problem using HASClay. As a countermeasure, the use of natural energy and the change of the fan for heat supply from a damper system to an inverter system to control the air volume were considered. For transport to the 10a scale, which has environmental advantages, a system was proposed in which the heat from the HASClay is divided into mini-tanks and transported to stations envisaged in each region, where it is collected by the agricultural producers. In summary, the authors concluded that our proposal for an agro-industrial fusion system based on the transport of heat using HASClay is an effective method for the realization of a sustainable society. The environmental benefits of the project are likely to attract participation from the industrial sphere in order to meet future demands for CO2 reductions.
Seafloor Massive Sulfides (SMSs), which were formed by deposition of precipitates from hydrothermal fluids vented from seafloor, has been expected as one of unconventional mineral resources on deep seafloors in the oceans. The authors have proposed the concept of seafloor mineral processing for SMS mining, where valuable minerals contained in SMS ores are separated on seafloor while gangue minerals are disposed on seafloor in appropriate ways. To confirm the applicability of column flotation, which is one of conventional mineral processing methods, to seafloor mineral processing, the authors carried out experiments simulating column flotation under the pressure conditions corresponding to the water depths down to 1000m in maximum using ore samples containing copper, iron, zinc and lead. In the experiments, formation of fine bubbles suitable to flotation and overflow of froth layer were observed at high pressures. The contents of copper and zinc in the concentrates recovered in the experiments at 1MPa were higher than those in the feed ores while the contents of silicon and calcium in the concentrates were lower than those in the feed ores. These results suggest that column flotation would be applicable to seafloor mineral processing.