This article introduces a power controller for three-phase inverters in microgrids that can be used in three-phase three-wire and three-phase four-wire systems. The controller enables active and reactive power tracking and unbalanced current control during grid-tied operation, while also allowing seamless transitions into islanded operation. The proposal is motivated by the compelling need in forthcoming power-electronics-dominated grids to provide ancillary services for the main grid and to support grid-forming functionalities for the microgrid, especially in case of islanded operation. The control is developed on the symmetrical components framework. Power tracking is achieved by dedicated control loops that, exploiting $P$$-$$f$ and $Q$$-$$V$ droop laws applied on positive-sequence powers, accommodate output-power control during grid-tied operation as well as grid-forming capabilities during islanded operation. The controller also includes synchronous $dq$ -frame control for negative-sequence current regulation for providing unbalanced current compensation. The proposed solution addresses the challenge of simultaneously providing concurrent grid-tied control features, such as output power tracking, during grid-tied operation as well as grid-forming capabilities during islanded operation. The related challenge stems from the intrinsically different control actions involved in the two modes of operation, namely, grid tied and islanded. The proposal is verified on an experimental setup composed of converters rated 3 kW.
This manuscript describes the operation of a droop-based controller for three-phase converters in the case of the absence of a neutral connection to the grid. The controller is capable of output power tracking and smooth transitions into the islanded operation. While independent per-phase control of the converter output power is possible if a neutral connection is present, its absence implies additional constraints to be considered. Focusing on this latter case, the controller described herein allows the independent control of the active power at the output of each phase of the converter and a smooth transition to the islanded operation. These features are paramount in future smart power systems, such as smart microgrids, for implementing demand–response, power-flow management, and uninterrupted power operation.
20 June 2024 in IEEE Open Journal of Power Electronics
Electronic power converters are extensively applied in microgrids to interface distributed energy resources to the grid. Besides the primary active-power control, electronic converters support increasingly advanced and flexible control capabilities. While the former is typically bound to local needs (e.g., maximum power extraction from renewables), additional degrees of freedom can be exploited to support microgrid operation. This article proposes a control algorithm that allows the optimal provision of reactive power, negative-sequence, and zero-sequence currents by distributed converters. The resulting operation shows enhanced power quality at the point of common coupling (PCC) and limited conversion losses, which are taken into account in the optimization algorithm. Three modes of operation are discussed, that is, i ) power loss minimization; ii ) balanced currents at the PCC; iii ) zero reactive power flow at the PCC. An algorithm based on the primal-dual method is proposed to solve the optimization problem. Results based on experimental measurements are discussed to prove the effectiveness of the proposal.
13 May 2026 in IEEE Journal of Emerging and Selected Topics in Power Electronics
This article proposes an auto-tuning control strategy for the power loop of grid-forming inverters to compensate the dynamic performance degradation caused by the variation of unknown variables (e.g., grid impedance, inverter parameter values) under grid-connected operating conditions. The autotuning is achieved by online monitoring the crossover frequency and phase margin of the power control loop, and adjusting key parameters of the droop controller according to these performance indices. It is shown that the crossover frequency and phase margin can be maintained at desired values, thus the expected dynamic control performance can be achieved and maintained. Simulation and experimental results are presented to demonstrate the effectiveness of the proposed approach.