The measurement of hydrogen concentration in fuel cell systems is an important prerequisite for the development of a control strategy to enhance system performance, reduce purge losses and minimize fuel cell aging effects. In this perspective paper, the working principles of hydrogen sensors are analyzed and their requirements for hydrogen control in fuel cell systems are critically discussed. The wide measurement range, absence of oxygen, high humidity and limited space turn out to be most limiting. A perspective on the development of hydrogen sensors based on palladium as a gas-sensitive metal and based on the organic magnetic field effect in organic light-emitting devices is presented. The design of a test chamber, where the sensor response can easily be analyzed under fuel cell-like conditions is proposed. This allows the generation of practical knowledge for further sensor development. The presented sensors could be integrated into the end plate to measure the hydrogen concentration at the anode in- and outlet. Further miniaturization is necessary to integrate them into the flow field of the fuel cell to avoid fuel starvation in each single cell. Compressed sensing methods are used for more efficient data analysis. By using a dynamical sensor model, control algorithms are applied with high frequency to control the hydrogen concentration, the purge process, and the recirculation pump.
The constructive design of a flow field layout and the channel cross section parameters from a metallic half- or bipolar plate can have a significant influence on the performance characteristics of a fuel cell. One important aspect in the dimensioning of the channel geometry of half plates is the technical forming feasibility. In this article, first an equation is presented, which enables an analytical calculation of the channel parameters. Hereby, continuing calculations with parameter variations will be possible. Furthermore, the formability of the channel geometry of metallic half plates is evaluated through numerical and experimental investigations. Based on the results, an analytical model approach will be derived that enables an appraisal of the formability from channel cross section contours in an early development state. As a final step, the results of the numerical investigations and the analytical calculation method are compared and evaluated with the results of experimental investigations and other publications. It will be shown, that the derived analytical model approach has a good approximation compared to the effects and results from the numerical and experimental analysis. In particular, the assessment of whether a channel cross section can be manufactured safely is a result with high probability of the analytical model approach. Imprecisions happen, especially in variants with extreme geometries, for example, with very small radii or a huge channel depth. For this kind of variations, the analytical model behaves too sensitively, which makes it more difficult to estimate the damage effects. However, at an early development state, the analytical model offers a good method to get a pre-evaluation of the formability of channel cross sections with a simultaneous parameter variation possibility.
7 November 2025 in International Journal of Hydrogen Energy
In fuel cell systems with an anode recirculation cycle that runs overstoichiometrically, an undesired enrichment of nitrogen and water vapor occurs due to their diffusion through the membrane-electrode-assembly (MEA). This causes an impairment of the power density. So far, this phenomenon was avoided by a time dependent purge strategy. During this process a lot of unconsumed hydrogen gets wasted. A more efficient purge strategy that reduces the waste and improves the system efficiency, which operates load dependently by means of the mass transfer coefficient, is introduced. A comparison of the system efficiency with and without the load-dependent-purge-strategy (LPS) is made and discussed in order to demonstrate the effectiveness of the new method. Static as well as dynamic system simulations were performed for this purpose. A notable improvement of the system efficiency of up to 10% with LPS was achieved. With LPS the purge power losses could be markedly reduced. This reformation also induces an improvement of the system efficiency, which brings us a considerable step forward towards a longer reach. Moreover, LPS is not restricted to a certain fuel cell system and thus affords a more flexible and versatile employment than its predecessor.