This study investigates the response of standing passengers on public transport who experience balance perturbations during non-collision incidents. The objective of the study was to analyse the effects of the perturbation characteristics on the initial responses of the passengers and their ability to maintain their balance. Sled tests were conducted on healthy volunteers aged 33.8 ± 9.2 years (13 males, 11 females) standing on a moving platform, facilitating measurements of the initial muscle activity and stepping response of the volunteers. The volunteers were exposed to five different perturbation profiles representing typical braking and accelerating manoeuvres of a public transport bus in the forward and backward direction. The sequence of muscle activations in lower-extremity muscles was consistent for the perturbation pulses applied. For the three acceleration pulses combining two magnitudes for acceleration (1.5 and 3.0 m/s2) and jerk (5.6 and 11.3 m/s3), the shortest muscle onset and stepping times for the passengers to recover their balance were observed with the higher jerk value, while the profile with the higher acceleration magnitude and longer duration induced more recovery steps and a higher rate of safety-harness deployment. The tendency for a shorter response time was observed for the female volunteers. For the two braking pulses (1.0 and 2.5 m/s2), only the lower magnitude pulse allowed balance recovery without compensatory stepping. The results obtained provide a reference dataset for human body modelling, the development of virtual test protocols, and operational limits for improving the safety of public transportation vehicles and users.
Cervical spine ligaments that protect the spinal cord and stabilize the spine are frequently injured in motor vehicle collisions and other traumatic situations. These injuries are usually incomplete, and often difficult to notice. The focus of the presented study is placed on analysis of the effect of subfailure load on the mechanical response of the three main cervical spine ligaments: the anterior and the posterior longitudinal ligament and the ligamentum flavum. A total of 115 samples of human cadaveric ligaments removed within 24-48 h after death have been tested. Uniaxial tension tests along the fiber direction were performed in physiological conditions on a custom designed test equipment. The ligaments were loaded into an expected damage zone at two different subfailure values (based on previously reported reference group of 46 samples), and then reloaded to failure. The main effect of a high subfailure load has proven to be the toe elongation change. The toe elongation increase is affected by the subfailure load value. While anterior and posterior longitudinal ligament showed similar changes, the smallest subfailure effect was found in ligamentum flavum. The normal physiological region of the cervical spine ligaments mechanical response is modified by a high subfailure load. The observed ligament injury significantly compromises ligament ability to give tensile support within physiological spinal motion.
Critical traffic situations, such as vehicle collisions and emergency manoeuvres, can cause an occupant to respond with reflex and voluntary actions. These affect the occupant’s position and dynamic loading during interactions with the vehicle’s restraints, possibly compromising their protective function. Electromyography (EMG) is a commonly used method for measuring active muscle response and can also provide input parameters for computer simulations with models of the human body. The recently introduced muscle-contraction (MC) sensor is a wearable device with a piezo-resistive element for measuring the force of an indenting tip pressing against the surface of the body. The study aimed to compare how data collected simultaneously with EMG, video motion capture, and the novel MC sensor are related to neck-muscle loading. Sled tests with low-severity frontal impacts were conducted, assuming two different awareness conditions for seated volunteers. The activity of the upper trapezius muscle was measured using surface EMG and MC sensors. The neck-muscle load F was estimated from an inverse dynamics analysis of the head’s motion captured in the sagittal plane. The volunteers’ response to impact was predominantly reflexive, with significantly shorter onset latencies and more bracing observed when the volunteers were aware of the impact. Cross-correlations between the EMG and MC, EMG and F, and F and MC data were not changed significantly by the awareness conditions. The MC signal was strongly correlated (r = 0.89) with the neck-muscle loading F in the aware and unaware conditions, while the mean ΔF-MC delays were 21.0 ± 15.1 ms and 14.6 ± 12.4 ms, respectively. With the MC sensor enabling a consistent measurement-based estimation of the muscle loading, the simultaneous acquisition of EMG and MC signals improves the assessment of the reflex and voluntary responses of a vehicle’s occupant subjected to low-severity loading.
1 October 2020 in Journal of the Mechanical Behavior of Biomedical Materials
The aim of the presented study was to estimate the material properties of human patellar ligaments from the elderly population by means of tensile tests. The experimental part was conducted on a custom tensile-testing device, with a built-in enclosure to simulate in-vivo conditions, using 25 (15 female, 10 male) bone-ligament-bone samples from elderly (age 83 (8)) human donors. During the tensile tests, the resultant force and displacement of the sample attachments were recorded. With this data and the values of the initial length and the initial cross-sectional area of the samples, the engineering stress and strain, the Young's modulus and the toughness at rupture were calculated for each sample. The results were then averaged and presented for all the samples together and for the female and male populations separately. The measured Young's modulus and the failure stress values were found to be significantly higher for the female samples compared to the male (p < 0.05). All the other measured properties did not show a significant difference. The toe region's material properties for the patellar ligament were also presented as valuable information for the anterior cruciate ligament reconstruction. The tensile-test results were compared to other research carried on human patellar ligaments using samples from younger donors. The comparison showed that the samples from the elderly population exhibit lower values of strain at the end of the toe region and have a lower failure strain for the patellar ligament. The Young's modulus and the failure stress of the samples in this study were in the range of other research conducted on patellar ligaments.
A traffic accident is a complex phenomenon with vehicles and human beings involved. During a collision, the vehicle occupant is exposed to substantial loads, which can cause the occupant injuries that depend on the level of passive safety, as well as on the occupant's individual characteristics. Correct estimation of injury severity demands a validated human body model and known impact conditions. A human body modelling procedure for the purpose of accident analysis is introduced. The occupant body has been modelled as a multibody system with rigid body segments connected. Geometrical and inertial properties of individual body segments were estimated using computed tomography. Frontal impact conditions were simulated on a sled test facility, while the human body dynamic response was measured. Comparison of experimental data and computer simulation revealed an influence of joint resistive properties on the occupant motion in collisions. The difference between measured and simulated response was minimised using optimisation method. Individualised human body modelling procedure enabled better prediction of the occupant motion during vehicle collision and thus more precise estimation of possible injuries in real-life traffic accidents.