Occupational health and safety hazards associated with confined places are mainly caused by exposure to toxic gases and oxygen deficiency. Lack of awareness, inappropriate monitoring, and improper evacuation methods can lead to worker fatalities. Although previous studies have attempted to develop systems to solve this issue, limited research is available on their application in confined places. In this study, a real-time helmet-mounted system was developed to monitor major toxic gases (methane (CH₄), hydrogen sulfide (H₂S), ammonia (NH₃), and carbon monoxide (CO)), oxygen, temperature, and humidity. Workers outside and inside confined spaces receive alerts every second to immediately initiate the rescue operation in the event of a hazard. The test results of a confined environment (wastewater treatment unit) highlighted that concentrations of CH₄ and H₂S were predominant (13 ppm). Compared to normal atmosphere, CH₄ concentration was 122- and 130-fold higher in the landfill and digestion tanks, respectively, while H₂S was 36- and 19-fold higher in the primary and secondary clarifiers, respectively. The oxygen content (18.2%) and humidity (33%) were below the minimum required limits. This study will benefit future research to target appropriate toxic gas monitoring and alert workers by studying the existing issues and associated factors in confined places.

Air pollution caused by the construction industry in the form of particulate matter (PM) has increased to an alarming level. The effects on the health of construction workers are found to be hazardous despite the current advancement in construction methods and practices. In particular, the efficiency of existing control measures for reducing PM from various construction activities has not been improved to the desired level. This study investigated the factors that influence the efficiency of a sprinkler system-based control measure when water spraying and dust suppressant solutions are used. The real-time PM exposure was measured during hollow-block cutting activity using Alphanese OPC-N3 sensors in dust chamber. The dust suppressant suppresses dust particles by initially forming a solidified film on the particle surface, and the high cohesion of this film enhances the suppression rate by promoting dust particle coagulation. It was observed that when using a dust suppressant, the PM concentration at 100 bar exceeded concentrations at other pressures, resulting in increased efficacy in reducing PM₁₀. Additionally, water spraying at 115 bar was determined to be the optimal control measure for achieving a significant percentage of PM reduction in a shorter period. These findings can be highly beneficial if the water sprinkler system can be modified into a smart mobility-based sprinkler system either ground-based or drone-based at construction sites in improving PM reduction efficiency particularly on high PM emitting activities.