Diego Brito

Mr. Diego Brito

Universidad Católica de la Santísima Concepción, Concepción, Biobío, Chile
orcid
Electrical Engineer

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
18 December 2022 in Mathematics
Verified
Journal Article
Open access
PDF file
GBGabriel Bout
Gabriel Bout
DBDiego Brito
Diego Brito
René Esteban GómezRené Esteban Gómez
René Esteban Gómez
GCGonzalo Carvajal
Gonzalo Carvajal
GAGuillermo Ramírez A.
Guillermo Ramírez A.
Measurement While Drilling (MWD) is a technology for assessing rock mass conditions by collecting and analyzing data of mechanical drilling variables while the system operates. Nowadays, typical MWD systems rely on physical sensors directly installed on the drill rig. Sensors used in this context must be designed and conditioned for operating in harsh conditions, imposing trade-offs between the complexity, cost, and reliability of the measurement system. This paper presents a methodology for integrating physics-based observers into an MWD system as an alternative to complement or replace traditional physical sensors. The proposed observers leverage mathematical models of the drill’s electrical motor and its interaction with dynamic loads to estimate the bit speed and torque in a Down-the-Hole rig using current and voltage measurements taken from the motor power line. Experiments using data collected from four test samples with different rock strengths show a consistent correlation between the rate of penetration and specific energy derived from the observed drilling variables with the ones obtained from standardized tests of uniaxial compressive strength. The simplicity of the setup and results validate the feasibility of the proposed approach to be evaluated as an alternative to reduce the complexity and increase the reliability of MWD systems.

7 April 2023 in Applied Sciences
Verified
Journal Article
Open access
PDF file
DBDiego Brito
Diego Brito
René Esteban GómezRené Esteban Gómez
René Esteban Gómez
GCGonzalo Carvajal
Gonzalo Carvajal
LRLorenzo Reyes-Chamorro
Lorenzo Reyes-Chamorro
GAGuillermo Ramírez A.
Guillermo Ramírez A.
In rotary-percussion drilling, the impact frequency is a crucial variable that is closely linked to operational factors that determine the efficacy of the drilling process, such as the rate of penetration, bit wear, and rock mass characteristics. Typical identification methods rely on complex simulation models or the analysis of different sensor signals installed on specially adapted setups, which are difficult to be implemented in the field. This paper presents a novel study where the impact frequency is identified by motor current signature analysis (MCSA) applied to an induction motor driving a DTH drilling setup. The analysis of the case study begins with the definition of characteristic drilling stages where the pressure and sound signals allow the detection of an impact frequency of 14.10 Hz, which is then used as a reference to validate three MCSA identification approaches. As a result of the analysis, the envelope approach is the most robust for nearly real-time implementations considering its simplicity and range of coverage. Experimental results provide evidence about the feasibility of the proposed MCSA methods to be integrated into Measurement-While-Drilling (MWD) systems to improve drilling condition monitoring and rock mass characterization.