The determination of the load bearing capacity of masonry in existing structures is not an easy task, even for experienced surveyors. For its assessment, it is necessary to know the compressive strength of the masonry units and mortar. Relatively good destructive and non-destructive methods were developed for the determination of the compressive strength of masonry units. However, mortar compressive strength determination is currently closer to a rough estimation rather than a deterministic approach. All of the currently used methods are either complicated, have a limited application, or are based on the surveyor’s experience only. Influence of the human factor on the results of testing is significant. The paper introduces the development of a new non-destructive method, which eliminates the influence of the human factor. The method is supposed to work as quickly and as easily as the Schmidt hammer used for concrete structure surveys. The new instrument was created where the compressive strength of mortar is assessed by hammering a steel bar into a joint with constant energy, while the depth of penetration is measured. The impact energy is provided by a steel spring with a prescribed stiffness, and the loading is provided by an automatic system similar to those used in air-soft guns.

Textile-reinforced concrete is becoming more and more popular. The material enables the realization of very thin structures and shells, often with organic shapes. However, a problem with this reinforcement occurs when the structure is bent (contains a corner), and the flexural stiffness around this bent area is required. This article presents the design, solution, and load-bearing capacity of an L-shaped rigid frame made of textile-reinforced concrete. Basic material parameters of concrete matrix and carbon textile reinforcement were supplemented by a four-point bending test to calibrate fracture energy Gf, critical compressive displacement Wd, solver type, and other parameters of a numerical model created by Atena Engineering in specialized non-linear structural analysis software for reinforced concrete structures. The calibrated numerical model was used to evaluate different variants of carbon textile reinforcement of the L-shaped frame. The carbon textile reinforcement was homogenized using epoxy resin to ensure the interaction of all fibers, and its surface was modified with fine-grained silica sand to increase the cohesion with the concrete matrix. Specimens were produced based on the most effective variant of the L-shaped frame reinforcement to be experimentally tested. Thanks to the original shaping and anchoring of the reinforcement in the corner area, the frame with composite textile reinforcement is rigid and can transmit the bending stresses in both positive and negative directions. The results of the mechanical loading test on small experimental specimens correspond well to the results of numerical modeling using Atena Engineering software.