This paper reports on a quantitative evaluation of data in microscopic X-ray fluorescence analysis of metallic objects. A new simple technique reducing the effects caused by the presence of irregularities on the surface is introduced. The algorithm is based on the assumption that the behavior of these irregularities is comparable to local tilting of the object under investigation. In scanning XRF microanalysis, more precise distributions of element concentrations could be obtained. In addition, a relief image of the scanned area can be reconstructed. This image is a picture similar to the eye view of the object from the direction of the detector. The results of measurements of two metallic specimens are presented. The X-ray spectrum of our X-ray tube was experimentally determined, as it was required for accurate calculations.
This paper describes how the K(alpha)/K(beta) count rate ratio of the characteristic X-rays of a given element can be applied to determine the depth at which a layer or a grain of that element is located. The theoretical background and a basic description of the K(alpha)/K(beta) technique are given in the introduction. The experimental part of the paper deals with measurements of thick standard pure iron, intermediately thick iron foils, and layers prepared with a powder of Prussian blue. All these specimens were analyzed alone, and they were also analyzed overlaid with a low Z matrix. The light matrix consisted of sheets of paper of known thickness. Paper was chosen, because we take into account the subsequent application of this technique to surveys of historical monuments. The relation between the K(alpha) count rate, the K(alpha)/K(beta) count rate ratio, and the distribution of iron in the paper matrix are presented here.
This paper summarizes the effects of irregular shape on the results of a quantitative X-ray fluorescence (XRF) micro-analysis. These effects become relevant when an XRF analysis is performed directly on an investigated material. A typical example is XRF analyses of valuable and historical objects whose measurements should be performed non-destructively and non-invasively, without taking samples. Several measurements and computer simulations were performed for selected metallic materials and shapes to evaluate the accuracy and precision of XRF. The described experiments and the corresponding Monte Carlo simulations were related to the XRF device designed and utilized at the Czech Technical University. It was found that the relative uncertainty was typically about 5–10% or even higher in quantitative analyses of minor elements due to irregular shapes of surfaces. This must be considered in cases of the interpretation of XRF results, especially in the cultural heritage sciences. The conclusions also contain several recommendations on how to measure objects under hard-to-define geometric conditions with respect to reduction in the surface effect in quantitative or semi-quantitative XRF analyses.