Incremental nonlinear dynamic inversion is a sensor-based control approach that promises to provide high-performance nonlinear control without requiring a detailed model of the controlled vehicle. In the context of attitude control of micro air vehicles, incremental nonlinear dynamic inversion only uses a control effectiveness model and uses estimates of the angular accelerations to replace the rest of the model. This paper provides solutions for two major challenges of incremental nonlinear dynamic inversion control: how to deal with measurement and actuator delays, and how to deal with a changing control effectiveness. The main contributions of this article are 1) a proposed method to correctly take into account the delays occurring when deriving angular accelerations from angular rate measurements; 2) the introduction of adaptive incremental nonlinear dynamic inversion, which can estimate the control effectiveness online, eliminating the need for manual parameter estimation or tuning; and 3) the incorporation of the momentum of the propellers in the controller. This controller is suitable for vehicles that experience a different control effectiveness across their flight envelope. Furthermore, this approach requires only very coarse knowledge of model parameters in advance. Real-world experiments show the high performance, disturbance rejection, and adaptiveness properties.

In this paper, we derive a sensor-based nonlinear dynamic inversion (NDI) control law for a nonlinear system with first-order linear actuators, and compare it to incremental nonlinear dynamic inversion (INDI), which has gained popularity in recent years. It is shown that, for first-order actuator dynamics, INDI approximates the corresponding NDI control law arbitrarily well under the condition of sufficiently fast actuators. If the actuator bandwidth is low compared to changes in the states, the derived NDI control law has the following advantages compared to INDI: 1) compensation of state derivative terms, 2) well-defined error dynamics, and 3) exact tracking of a reference model, independent of error controller gains in nominal conditions. The comparison of the INDI control law with the well-established control design method NDI adds to the understanding of incremental control. It is additionally shown how to quantify the deficiency of the INDI control law with respect to the exact NDI law for actuators with finite bandwidth. The results are confirmed through simulation results of the roll motion of a fixed-wing aircraft.

Micro Aerial Vehicles (MAVs) are limited in their operation outdoors near obstacles by their ability to withstand wind gusts. Currently widespread position control methods such as Proportional Integral Derivative control do not perform well under the influence of gusts. Incremental Nonlinear Dynamic Inversion (INDI) is a sensor-based control technique that can control nonlinear systems subject to disturbances. This method was developed for the attitude control of MAVs, but in this paper we generalize this method to the outer loop control of MAVs under gust loads. Significant improvements over a traditional Proportional Integral Derivative (PID) controller are demonstrated in an experiment where the drone flies in and out of a fan's wake. The control method does not rely on frequent position updates, so it is ready to be applied outside with standard GPS modules.

To participate in the Outback Medical Express UAV Challenge 2016, a vehicle was designed and tested that can autonomously hover precisely, takeoff and land vertically, fly fast forward efficiently, and use computer vision to locate a person and a suitable landing location. The vehicle is a novel hybrid tail‐sitter combining a delta‐shaped biplane fixed‐wing and a conventional helicopter rotor. The rotor and wing are mounted perpendicularly to each other,and the entire vehicle pitches down to transition from hover to fast forward flight where the rotor serves as propulsion. To deliver sufficient thrust in hover while still being efficient in fast forward flight, a custom rotor system was designed. The theoretical design was validated with energy measurements, wind tunnel tests, and application in real‐world missions. A rotor‐head and corresponding control algorithm were developed to allow transitioning flight with the nonconventional rotor dynamics that are caused by the fuselage rotor interaction. Dedicated electronics were designed that meet vehicle needs and comply with regulations to allow safe flight beyond visual line of sight. Vision‐based search and guidance algorithms running on a stereo‐vision fish‐eye camera were developed and tested to locate a person in cluttered terrain never seen before. Flight tests and a competition participation illustrate the applicability of the DelftaCopter concept.