The packaging materials industry has already recognized the importance of Total Productive Maintenance as a system of proactive techniques for improving equipment reliability. Bearing faults, which often occur gradually, represent one of the foremost causes of failures in the industry. Therefore, detection of their faults in an early stage is quite important to assure reliable and efficient operation. We present a new automated technique for early fault detection and diagnosis in rolling-element bearings based on vibration signal analysis. Following the wavelet decomposition of vibration signals into a few sub-bands of interest, the standard deviation of obtained wavelet coefficients is extracted as a representative feature. Then, the feature space dimension is optimally reduced to two using scatter matrices. In the reduced two-dimensional feature space the fault detection and diagnosis is carried out by quadratic classifiers. Accuracy of the technique has been tested on four classes of the recorded vibrations signals, i.e., normal, with the fault of inner race, outer race, and ball operation. The overall accuracy of 98.9% has been achieved. The new technique can be used to support maintenance decision-making processes and, thus, to increase reliability and efficiency in the industry by preventing unexpected faulty operation of bearings.
Detecting and alerting for falls is a crucial component of both healthcare and assistive technologies. Wearable devices are vulnerable to damage and require regular inspection and maintenance. Manned video surveillance avoids these problems, but it involves constant labor-intensive attention and, in most cases, may interfere with the privacy of the observed individuals. To address this issue, in this work we introduce and evaluate a novel approach for fully automated fall detection. The presented technique uses direct reconstruction of principal motion parameters, avoiding the computationally expensive full optical flow reconstruction and still providing relevant descriptors for accurate detections. Our method is systematically compared with state-of-the-art techniques. Comparisons of detection accuracy, computational efficiency, and suitability for real-time applications are presented. Experimental results demonstrate notable improvements in accuracy while maintaining a lower computational cost compared to traditional methods, making our approach highly adaptable for real-world deployment. The findings highlight the robustness and universality of our model, suggesting its potential for integration into broader surveillance technologies. Future directions for development will include optimization for resource-constrained environments and deep learning enhancements to refine detection precision.
For several decades, intensive research for understanding gene activity and its role in organism’s lives is the research focus of scientists in different areas. A part of these investigations is the analysis of gene expression data for selecting differentially expressed genes. Methods that identify the interested genes have been proposed on statistical data analysis. The problem is that there is no good agreement among them, as different results are produced by distinct methods. By taking the advantage of the unsupervised data analysis, an iterative clustering procedure that finds differentially expressed genes shows promising results. In the present paper, a comparative study of the clustering methods applied for gene expression analysis is presented to explicate the choice of the clustering algorithm implemented in the method. An investigation of different distance measures is provided to reveal those that increase the efficiency of the method in finding the real data structure. Further, the method is improved by incorporating an additional aggregation measure based on the standard deviation of the expression levels. Its usage increases the gene distinction as a new amount of differentially expressed genes is found. The method is summarized in a detailed procedure. The significance of the method is proved by an analysis of two mice strain data sets. The differentially expressed genes defined by the proposed method are compared with those selected by the well-known statistical methods applied to the same data set.
Detecting and alerting for falls is a crucial component of both healthcare and assistive technologies. Wearable devices are vulnerable to damage and require regular inspection and maintenance. Manned video surveillance avoids these problems but it involves constant labor-intensive attention and, in most cases, may compromise the privacy of the observed individuals. To address the issue, in the work we introduce and evaluate a novel approach to fully automated fall detection. The presented technique uses direct reconstruction of principal motion parameters, avoiding the computationally expensive full optical flow reconstruction and still providing relevant descriptors for accurate detections. Our method is systematically compared with state-of-the-art techniques. Comparisons of detection accuracy, computational efficiency, and suitability for real-time applications are presented. Experimental results demonstrate notable improvements in accuracy while maintaining a lower computational cost compared to traditional methods, making our approach highly adaptable for real-world deployment. The findings highlight the robustness and universality of our model, suggesting its potential for integration into broader surveillance technologies. Future directions for development will include optimization for resource-constrained environments and deep learning enhancements to refine detection precision.
Certain professions rely on the ability to maintain attention constant throughout long periods of time, like truck drivers, air traffic controllers, health professionals, among others. These could greatly benefit from the development of a real-time alerting system that will call subjects back to task even before lapses occur or shortly after they happened. Attention levels have been shown to relate to the properties of the electroencephalogram (EEG). In this paper, we propose for the first time a regression approach to detect fluctuating levels of attention, based on spatiotemporal patterns extracted from EEG recordings. Previous studies have shown that reaction time is related to the level of task related attention. Moment-to-moment fluctuations in attention level are paralleled by moment-tomoment fluctuations in reaction time (faster reaction times are related to high attention allocation). We took advantage of this parallel and used reaction time data obtained during a repetitive visuomotor task as a proxy for task related attention level. Furthermore, instead of defining high attention versus low attention periods, we labeled each moment according to a continuum based on each trial's reaction time. In order to determine if it is possible to predict attention level from EEG features, we developed regression models between the extracted features and the subject's reaction time.