The effect of hammer peening on the fatigue resistance of high strength welded steel S690 has been investigated. Cyclic four points bending tests have been performed on butt weld samples, manually and automatically hammered. Microstructural and mechanical modifications induced by both methods and their subsequent influences on fatigue life have been studied using several characterization techniques. A comparison of residual stress measurements using X-ray diffraction shows also differences between methods. On the other hand, hardness profile of the strain hardened region is very similar for both types of samples. The ultra-fine grain microstructure of the heat-affected zone (HAZ) induced by the hammer peening process has been studied by Field Emission Scanning Electron Microscopy and Electron Back Scattered Technique (EBSD). In fatigue as expected, hammer peening increases the fatigue strength of weld structures in good agreement with the latest proposal of the International Institute of Welding (IIW). Compressive residual stresses play a key role. Microstructure does not seem to affect fatigue strength in spite of nanostructured layer. On the contrary to what is usually admitted, the local geometry of the weld toe is deteriorated because the process induces crack-like folds. In this paper, some recommendations are proposed for the hammer peening process in terms of sweeping strategy.
A large percentage of power, petroleum, and chemical plants over the world were in operation for a long duration with the corresponding critical components being used beyond the design life of 30 to 40 years. It is generally more cost-effective to refurbish or modernize the degraded equipment or components, rather than to construct a new plant. Therefore, a reliable plant life extension assessment that can evaluate the critical components is needed. The key element in plant life extension is the residual life assessment technology. However, at present, there is still no general consensus among the industry players on the approach to adopt when performing residual life assessment for such a critical damage mechanism as creep. In this article, a three-level residual life assessment methodology is proposed as a general approach for high-temperature components prone to creep. A detailed validation of the selected guidelines and calculation models is also described. Eventually, an application of the three-level methodology to a real industrial case study is presented.
Traditionally, components of hardened steels, such as bearings, gears, shafts and rails, are finished by grinding process. In this study, Precision Hard Turning (PHT) is proposed as an alternative finishing process to manufacture AISI 52100 bearing components (60-62 HRC), because PHT improves surface integrity and therefore increases the Rolling Contact Fatigue (RCF) life. An experimental design is used, under dry condition using cubic Boron Nitride (c-BN) cutting tools, to investigate the effect of cutting parameters on surface integrity characterised via surface roughness, microstructure analysis and residual stresses. Then, fatigue life tests are performed on a twin-disk machine. SEM observations of transversal cross-sections of all samples show the presence of a very fine and white layer (<1μm) on the top surface and a thermal affected zone of 40-50μm in the sub- surface. PHT does not affect quantitatively the percentage of the different microstructural phases and leads to decrease the number of dislocations in the transition zone compared to the bulk material, which is correlated to decrease of nanohardness in the transition zone. Compressive residual stresses are measured in surface and sub-surface and their level is more in compression in the circumferential direction than in tangential direction. Levels of roughness decrease as cutting speed increases. RCF life of bearing steel components machined by PHT reached 5.2 (at Ra=0.11μm) and 0.32 million cycles (at Ra=0.25μm). Therefore, RCF life increases as the roughness amplitude Ra decreases