In this study, pure titanium equivalent to Grade 1 was subjected to tensile tests at strain rates ranging from 10−6 to 100 s−1 to investigate the relationship between its mechanical properties and its twinning and slip. Deformation properties and microstructures of samples having average grain sizes of 210 μm (Ti-210), 30 μm (Ti-30), and 5 μm (Ti-5) were evaluated. With increasing strain rates, the 0.2% proof stress and ultimate tensile strength increased for all samples; the fracture strain increased for Ti-210, decreased for Ti-5, and changed negligibly for Ti-30. Comparing high (100 s−1) and low (10−6 s−1) strain rates, twinning occurred more frequently in Ti-30 and Ti-210 at high strain rates, but the frequency did not change in Ti-5. The frequency of 1st order pyramidal slip tended to be higher in Ti-30 and Ti-5 at low strain rates. The higher ductility exhibited by Ti-210 at high strain rates was attributed to the high frequency of twinning. In contrast, the higher ductility of Ti-5 at low strain rates was attributed to the activity of the 1st order pyramidal slip.
To investigate the factors that cause variations in the friction coefficients of commercially pure titanium sheets with titanium oxide films, the sliding deformation during ball-on-block sliding tests was observed in situ and compared with electron backscatter diffraction analyses of the same regions. Under a vertical load of 0.1 N, the friction coefficient was stable at a low level of approximately 0.12. By contrast, at 0.5 N, the friction coefficient fluctuated widely between 0.20 and 0.80. At 2.0 and 4.0 N, the friction coefficient was stable again at a high level of approximately 0.30 and 0.40, respectively. The fluctuation in friction coefficient at a vertical load of 0.5 N was investigated further based on the Taylor factor for the uniaxial compression of the titanium grains directly beneath the contact point. Notably, the friction coefficient was negatively correlated with the Taylor factor of the underlying grains. Thus, it can be presumed that the plowing term of the friction coefficient increases as the compressive strain on titanium increases. At vertical loads of 2.0 and 4.0 N, the contact area is larger, so the ball is always in contact with multiple grains. Thus, the influence of the Taylor factor of individual grains can be assumed to be averaged, thereby reducing the variation in friction coefficient.
To investigate the factor that cause the variation in friction coefficient by sliding conditions in commercially pure titanium coated titanium oxide film, in-situ observation of sliding interface during ball on block test and EBSD analysis of a sliding cross-section were performed. At the vertical load of 0.1 N, the friction coefficient stabilized at a low level of approximately 0.12. However, at 0.5 N, the friction coefficient varying widely in the range of 0.20–0.80. At 2.0 and 4.0 N, the friction coefficient stabilized at a high level, approximately 0.30 and 0.40, respectively. At the vertical load of 0.5 N, the friction coefficient was negatively correlated to the Taylor factor for the uniaxial compression of the titanium grains directly beneath the film . Thus, it can be presumed that the ploughing term of friction coefficient increased due to the enhancement of compressive strain of titanium. On the other hands, at vertical loads of 2.0 and 4.0 N, the ball is always in contact with multiple grains due to the larger contact area. As a result, it is considered that the influence of Taylor factor was equalized and the variation of friction coefficient got smaller.