This paper investigates in detail the effects of measurement noise on the performance of reservoir computing. We focus on an application in which reservoir computers are used to learn the relationship between different state variables of a chaotic system. We recognize that noise can affect the training and testing phases differently. We find that the best performance of the reservoir is achieved when the strength of the noise that affects the input signal in the training phase equals the strength of the noise that affects the input signal in the testing phase. For all the cases we examined, we found that a good remedy to noise is to low-pass filter the input and the training/testing signals; this typically preserves the performance of the reservoir, while reducing the undesired effects of noise.
With the increase in demand for spectral resources and bandwidth constraints, efficient solutions for the coexistence of radar and communication systems are needed. Simultaneously, the development of multifunctional radio frequency (RF) systems with less hardware have received considerable attention. Most previous work on coexistence has focused on hardware design and mitigation of interference between radar and communication systems. This work proposes, a novel method for controlling a chaotic trajectory, which allows for the coexistence of both radar and communication systems. Binary information can be encoded in a chaotic state by adjusting its trajectory. In this approach, a state variable is selected to control the trajectory and generate a controlled chaos-based frequency modulated (CCBFM) waveform for joint radar-communication system signal transmission. We also design a communication receiver to decode the information and a radar receiver that extracts the signature of the target are designed accordingly. The performance of the controlled chaotic communication system is assessed in terms of the bit error ratio (BER). The analysis of the communication system shows that the CCBFM receiver performs reasonably well compared to a half-sine pulse frequency modulated (HSPFM) receiver. Analysis of the radar system performance is assessed using the entropy of the target's signature. The use of a CCBFM waveform leads to accurate target detection and classification for a signal-to-noise ratio as low as -30 dB. These analyses demonstrate that a CCBFM waveform can be successfully used for joint radar-communication systems in a shared spectrum.
In this article, we propose the utilization of chaos-based frequency modulated (CBFM) waveforms for joint monostatic and bistatic radar-communication systems. Short-duration pulses generated via chaotic oscillators are used for wideband radar imaging, while information is embedded in the pulses using chaos shift keying (CSK). A self-synchronization technique for chaotic systems decodes the information at the communication receiver and reconstructs the transmitted waveform at the bistatic radar receiver. Using a nonlinear detection scheme, we show that the CBFM waveforms closely follow the theoretical bit-error rate (BER) associated with bipolar phase-shift keying (BPSK). We utilize the same nonlinear detection scheme to optimize the target detection at the bistatic radar receiver. The ambiguity function for both the monostatic and bistatic cases resembles a thumbtack ambiguity function with a pseudo-random sidelobe distribution. Furthermore, we characterize the high-resolution imaging capability of the CBFM waveforms in the presence of noise and considering a complex target.
9 March 2017 in IEEE Transactions on Aerospace and Electronic Systems
The authors report the simulation and actual implementation of chaotic oscillator synchronization for a pair of three-state variable Lorenz systems. The first oscillator performs as a driver (transmitter), while the second system is made to respond the received waveform. Specifically, one of the state variables of the driver circuit is judiciously selected to generate an RF waveform. This waveform is transmitted through a noisy channel and is used to drive the response system until both the systems of all three state variables achieve complete replacement synchronization. It is known that this synchronization is sensitive to changes in received power. To overcome this, a technique hereon called generalized projective synchronization is employed to accept an attenuated version of the transmitted waveform. A sensitivity analysis reveals that generalized projective synchronization is robust with respect to deviations in the control parameter values of the response system due to tolerances of electronic components. The potential of the generalized projective synchronization is illustrated for a bistatic radar system case, where synchronization is necessary to obtain the range-Doppler information of a moving target. In this instance, the cross correlation, short-time cross-correlogram and cross ambiguity surface of the transmitted and synchronized waveforms are of high quality as indicated by their entropy measures.
The authors developed a technique to synchronise a bistatic radar that uses a chaotic system to generate and process either wideband amplitude modulated (AM) or frequency modulated (FM) waveforms thereby extracting high‐resolution information from the targets. For chaotic AM bistatic radar, a generalised projective synchronisation approach that includes a driving oscillator at the transmitter and a response oscillator at the receiver is considered. The receiver accepts a scaled version of the transmitted waveform where the scaling factor α accounts for space propagation losses that may not be known a priori. However, AM synchronisation is highly susceptible to noise. Alternatively, FM bistatic radar is implemented with a chaos‐based FM waveform. Demodulation of this waveform using a phase lock loop is required to recover the instantaneous frequency which represents a chaotic state variable. The recovered and transmitter instantaneous frequencies are synchronised by using either generalised projective synchronisation or complete replacement synchronisation. The synchronised output is then used to reconstruct the FM waveform. They show that the short‐time cross‐correlation of the transmitted and reconstructed waveforms is high and its self‐noise is negligible. Through entropy analysis of the cross‐correlogram, they found that the bistatic FM radar performs better than the bistatic AM radar.