In this work, we report the systematic investigation of a multiresponsive complex coacervate-based underwater adhesive, obtained by combining polyelectrolyte domains and thermoresponsive poly(N-isopropylacrylamide) (PNIPAM) units. This material exhibits a transition from liquid to solid but, differently from most reactive glues, is completely held together by non-covalent interactions, i.e., electrostatic and hydrophobic. Because the solidification results in a kinetically trapped morphology, the final mechanical properties strongly depend on the preparation conditions and on the surrounding environment. A systematic study is performed to assess the effect of ionic strength and of PNIPAM content on the thermal, rheological and adhesive properties. This study enables the optimization of polymer composition and environmental conditions for this underwater adhesive system. The best performance with a work of adhesion of 6.5 J/m² was found for the complex coacervates prepared at high ionic strength (0.75 M NaCl) and at an optimal PNIPAM content around 30% mol/mol. The high ionic strength enables injectability, while the hydrated PNIPAM domains provide additional dissipation, without softening the material so much that it becomes too weak to resist detaching stress.

Microfluidic flow-focusing devices offer excellent control over fluid flow, enabling formation of drops with a narrow size distribution. However, the throughput of microfluidic flow-focusing devices is limited and scale-up through operation of multiple drop makers in parallel often compromises the robustness of their operation. We demonstrate that parallelization is facilitated if the outer phase is injected from the direction opposite to that of the inner phase, because the fluid injection flow rate, where the drop formation transitions from the squeezing into the dripping regime, is shifted towards higher values.

Solar devices based on semiconductor nanoparticles require the use of conductive ligands; however, replacing the native, insulating ligands with conductive metal chalcogenide complexes introduces structural defects within the crystalline nanostructure that act as traps for charge carriers. We utilized atomically thin semiconductor nanoplatelets as a convenient platform for studying, both microscopically and spectroscopically, the development of defects during ligand exchange with the conductive ligands Na₄SnS₄ and (NH₄)₄Sn₂S₆. These defects can be repaired via mild chemical or thermal routes, through the addition of L‐type ligands or wet annealing, respectively. This results in a higher‐quality, conductive, colloidally stable nanomaterial that may be used as the active film in optoelectronic devices.