Cable-membrane constructions typically exhibit significant displacement and distortion under load action, and the cable-membrane contact results in relative sliding. In this paper, the interaction force between cable and membrane is transferred through frictional contact action, and as a result, the friction coefficient must be taken into consideration for the form-finding and load analysis of air-supported membrane structures. Eight kinds of P-type membrane materials commonly used in engineering were chosen, and the friction coefficients between the various membrane and cable materials were obtained. The connection between a cable and a membrane of an air-supported membrane structure is considered a contact problem, and its initial shape analysis and wind load response analysis are carried out. The influence of the friction coefficient of a cable membrane on the wind-induced response of an air-supported membrane structure is discussed, and the results are compared with those of the cable-membrane binding model under wind load.

The cable net and membrane of the air-supported membrane structure transmits the load through mutual extrusion, and the contact interaction between the cable net and membrane should be considered in the initial morphological analysis stage. In this paper, a scale model was designed according to a large-span air-supported membrane structure engineering project, and the shape and force of the structure were measured. At the same time, a finite element model of cable–membrane contact was established, and its interaction behavior was regarded as a combined contact state and sliding contact state. The results show that the influence of different contact state analyses on the prestress of the cable net is obvious, and the influence of the sliding contact between the cable and the membrane should be considered in the design of the membrane structure.

Large-span roofs can be damaged by uneven snow loads caused by snow drifting. To predict wind-induced snow loads more accurately, this paper proposes a numerical simulation method. The method considers the interaction of wind and snow, the changing characteristics of snow phase boundaries over time, and corrects for snow deposition and erosion flux. The effectiveness of the method was confirmed by simulating wind–snow flow on a three-centered cylindrical shell and comparing the results with wind tunnel measurements. The simulation considered different snowfall conditions and time-varying snow phase boundaries on a large-span shell-shaped roof. The study investigated the influence of snowfall conditions and dynamic changes in snow phase boundaries on snow cover distribution by comparing simulation results.

The air supported membrane structure is a typical nonlinear flexible long-span space structure, the wind-induced drift and the resulting accumulation and distribution of snow particles on the structure may be the primary design concern among all loads in heavy-snowfall region. Thus, an accurate prediction of snow distribution on membrane surface is vital to structural design. A numerical simulation method is used to estimate snowdrift in this paper. Based on Euler-Euler method in multi-phase flow theory, this numerical model adopted Mixture model and combined with the snow deposition and erosion model, the snowdrift on an air-supported membrane coal shed is simulated, the distribution factor for roof snow load is given under different wind speed and different directions to estimate the worst load case, snow load on the air-supported membrane structure is significantly affected by snowdrift which causes significant non-uniform snow load. Furthermore, the response analysis of the air-supported membrane structure under snow load is studied, for comparison, uniform snow load case, non-uniform snow load case, and simulated snow load case under 0° wind direction are all considered. The results show that non-uniform snow load caused by snow drifting is more dangerous and should be considered.