Mohammed Osman Ali Mohammed

Dr. Mohammed Osman Ali Mohammed

environmental health, University of Khartoum, Khartoum, Sudan
orcid

Research Focus & Metrics

Academic Career Length

18Years (2009-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 February 2023 in Atmosphere
Verified
Journal Article
Open access
PDF file
MMMohammed Osman Ali Mohammed
Mohammed Osman Ali Mohammed
Studies on indoor air quality (IAQ) have linked exposure to microorganisms in indoor air to a variety of illnesses. The association between indoor air quality, surface contamination, and IAQ under heterogeneous cleaning procedures are all crucial factors that were investigated in this study. The ATP bioluminescence test demonstrated a significant correlation (r = 0.89; p 0.05) with bacterial count obtained from swab specimens and a moderate correlation (r = 0.57; p 0.001) with viable settling bacterial count. For the entire sample (pre- and post-cleaning), the ATP values were heterogeneous, averaging 230 RLU/100 cm2, 140 RLU/100 cm2, 120 RLU/100 cm2, 135 RLU/100 cm2, 99 RLU/100 cm2, and 80 RLU/100 cm2, in offices, classrooms, toilet doorknobs, reception desks, main lobbies, and exit doorknobs, respectively. An insignificant association between indoor and outdoor PM2.5 (r = 0.21; p 0.05), an I/O ratio of PM2.5 with an average value of 1.2, and an I/O ratio of CO2 exceeding 1 suggest a minor impact of outdoor air. After cleaning, the bacterial and fungal counts on indoor surfaces showed significant reduction, suggesting that the cleaning procedures were effective. The concentrations of VOC but not HCHO in indoor air were significantly affected by cleaning, but not by temperature or relative humidity (RH). We propose ATP bioluminescence as a surrogate for detecting bacterial contamination rather than fungal contamination, which requires additional validation. We suggest that the results of active microbial sampling (in CFU/m3) and settling plates (in CFU/m2/h) be interpreted independently to avoid confusion.

1 September 2016 in Atmospheric Pollution Research
Verified
Journal Article
Open access
MMMohammed Osman Ali Mohammed
Mohammed Osman Ali Mohammed
Weiwei SongWeiwei Song
Weiwei Song
LLLi-Yan Liu
Li-Yan Liu
WMWan-Li Ma
Wan-Li Ma
YLYi-Fan Li
Yi-Fan Li
NLNa Lv
Na Lv
Simultaneous measurements of fine (PM2.5) and coarse (PM10) particles have been performed during three sampling period: summertime, early winter before the heating period, and during the winter heating. The sampling was done at an urban site, Harbin City, China, to apportion pollution sources and to investigate the impacts of weather parameters and emission sources on distribution patterns of PM2.5 and PM10 and their chemical compositions. Two chemometric techniques, hierarchical clustering analysis (HCA) and discriminant analysis (DA), and a receptor model (PMF5) were applied. The average mass concentrations of fine and coarse particles during the whole study period (i.e. annual averages), were 82.4 μg/m3 and 120.1 μg/m3, with relative humidity and wind speed being the main factors influencing distribution patterns of PM2.5 and PM10, while sum of major ions (NO3−, NH4+, SO42−), and organic carbon (OC) were the greater contributor to total mass concentrations. According to DA, the distribution patterns of PM2.5 and PM10 during the winter heating period were distinct but overlapping in summer and early winter before heating, implying that, PM2.5 and PM10 were originated from different sources during the winter heating period but from similar sources during the other two sampling periods. This claim was further supported by PMF results. Canonical discriminant function coefficients of DA have shown species such as OC, EC, SO42−, NO3−, Cl−, Ti, Sr, Ca2+, Ni, and Ba to be good predictors/discriminants responsible for the differences between the three sampling periods. HCA visualized the interrelations among the source markers, while the PMF5 modeling confirmed HCA findings

8 October 2021 in Environmental Science and Pollution Research
Verified
Journal Article
Closed access
PDF file
MMMohammed Osman Ali Mohammed
Mohammed Osman Ali Mohammed
AEAhmed A. Elzaki
Ahmed A. Elzaki
BBBabiker A. Babiker
Babiker A. Babiker
OEOmer I. Eid
Omer I. Eid

18 April 2024 in Polish Journal of Environmental Studies
Verified
Journal Article
Open access
MMMohammed Osman Ali Mohammed
Mohammed Osman Ali Mohammed
There is a real need for comparability and consistency of findings obtained from different multivariate methods, based on different assumptions and sensitivity to data errors. This study aims to investigate essential aspects of data screening prior to analysis, particularly the detection of outliers, communalities, multicollinearity, and Kaiser-Meyer-Olkin (KMO) and Bartlett’s tests, and to examine the influence of changing test parameters such as the number of convergence, number of bootstrap runs, FPEAK value, and minimum value of coefficient of determination (R2) on model results. Positive matrix factorization (PMF) and Unmix were applied to monitoring data collected from a receptor site. Findings of communalities estimate and multicollinearity indicated possible data errors in Ca, Cu, Na, and Mn, which affected the stability of source profiles. PMF detected biomass burning, coal combustion, traffic, industrial emissions, Mn-enriched sources, and secondary aerosols, while the Unmix model identified similar sources with comparable profiles, apart from profiles of vehicle exhaust and industrial emissions showing slight differences. Unmix was highly influenced by outliers, multicollinearity, and, to a lesser extent, change in sample size compared to PMF. We recommend interpreting the results of Bootstrapping, rather than basic runs for both PMF and Unmix. We also recommend data screening prior to further modeling. We suggest checking multicollinearity using more than one statistical measure, particularly VIF (Variance Inflation Factor) values together with tolerance values.

23 March 2022 in Polish Journal of Environmental Studies
Verified
Journal Article
Closed access
MMMohammed Osman Ali Mohammed
Mohammed Osman Ali Mohammed
ASAbdalmoiz A. M. Solumon
Abdalmoiz A. M. Solumon
Access to sufficient quantities of safe water is not just a public health issue but also a human right. Water pollution causes millions of deaths and illnesses every year. To solve the issue of water pollution at household levels and during emergencies, slow sand filters are suggested as good choices. This study aimed at designing small scale Household Slow Sand Filter (HSSF) with locally available materials. This experimental study was conducted under ambient weather conditions to test efficiency of two proposed filters in removing pollutants from source water. Natural water samples were collected from the Blue Nile, and the White Nile. The two filters were first cleaned up followed by a ripening period of two weeks to allow formation of the Schmutzdecke (the biological layer). Data were subjected to Hierarchical cluster analysis (HCA), ANOVA and Pearson correlation. The current research revealed that, both filters were highly efficient in removing E.coli and total coliform. The average log10 removal of total Coliforms and E Coli for the first filter ranged between 1.9 log and 1.7 log compared to a range of 1.1 log to 1.2 log for the second filter. The association of log10 total coliforms with turbidity and TSS has drastically changed after filtration. Overall, the best performance of filter 1 was reported for removal of bacteria, turbidity, iron (Fe), TSS, K and NO2, and Zn, respectively, versus NO2, Fe and Zn for filter 2, in the same order. The trend of ions removal assumed to be affected by both mineralization and oxidation which further supported by HCA results and it was differ than the pattern of heavy metals removal that was generally moderate not exceeded 65%. All soluble ions after filtration did not exceeded WHO guideline limits. The first proposed filter suggested to be efficient that need to be confirmed by further studies.

28 March 2025 in Knowledge Management & E-Learning: An International Journal
Verified
Journal Article
Open access
PDF file
MMMohammed Osman Ali Mohammed
Mohammed Osman Ali Mohammed
MHMuhanad El Hag
Muhanad El Hag
MIMohamed A. E. M. Ibrahim
Mohamed A. E. M. Ibrahim
JKJaved Khan
Javed Khan
The Blended learning system (BELS) has become a popular tool of learning. BELS’s effectiveness is substantially influenced by a number of elements, including teacher and student feedback and system design. This study on evaluating the Blackboard platform (removed for peer review) aims to determine the similarity between students’ and faculty members’ perspectives, identify the least satisfied elements of learning that need improvement, and collect suggestions for future enhancements. Using the SurveyMonkey service, questionnaires were sent directly to the emails of students and faculty members at the four colleges of the university. There were 1170 responses from students and 93 responses from staff members. SAS JMP was used to perform Linear Discriminant Analysis (LDA) to show the relationships between academic staff perceptions and their recommendations from one side and the students’ perceptions and satisfactions distributed by colleges from another side, while SPSS was used to visualize the data. Students and faculty were highly satisfied with blended learning and high expectations for its effectiveness The perceptions of faculty members were similar to those of students; however, they were more satisfied with certain features than students were. The LDA results of staff survey demonstrated that the responses of faculty members vary by college, unlike the LDA for students’ survey that did no show between-college variations. This implies that, students across colleges have similar needs and common attitudes toward BEL. Students were least satisfied with peer interactions; online IT assistance; the development of skills using current students’ activities; and the update frequency and quality of online content. We advocate incorporating student perspectives into plans and considering faculty members’ suggestions particularly for increasing peer-to-peer learning; in-line translation and use of infographics.