A scanning magnetometer based on a magnetoimpedance sensor with a 1 mm spatial resolution and 10 nT sensitivity was used to study stray magnetic fields of Fe74B13Si11C2 amorphous ferromagnetic microwires. Spatial magnetic images and vertical component profiles of stray magnetic fields of the studied microwires were obtained in a longitudinal homogeneous magnetic field of Helmholtz coils with a strength in the range of ±600 A/m. A magnetic calculation method is suggested that allows for using the measured magnetic fields to determine the magnitude and pattern of magnetization for the microwire. Characteristic values of the microwires’ average magnetization and width of closure domains for various values of bias fields were found.
A method for the determination of the thermal conductivity of polymer composite materials by using Co-based ferromagnetic microwires is proposed. Microwire segments were integrated into the samples of studied materials during their manufacture and used as current microheaters and resistance thermometers. As a representative material, we used a material based on nitrile butadiene rubber filled with hexagonal boron nitride after its low-temperature carbonization and a significant increase in thermal conductivity. The thermal conductivity values of composite samples determined during experiments varied from 1.0 W/(m·K) to 1.8 W/(m·K) depending on the percentage of boron nitride. The thermal conductivity values obtained are in good agreement with the estimates obtained by the standard laser flash method.
The maximum achievable parameters of magnetometers based on optomechanical quartz variometers are studied in connection with the planned transition of the international network Intermagnet to 1-s recording and the need to provide the network of Russian geomagnetic observatories with domestic magnetometers that satisfy Intermagnet requirements. The mechanism of negative feedback effect on the sensitivity threshold of a variometer with an optoelectronic angle transducer is shown. The optimization criterion for the size and shape of the magnets made of different magnetic materials is defined by the maximum ratio of the magnetic moment to the inertial moment. Theoretical and experimental evaluation of the variometer noise level is based on vicalloy and samarium–cobalt. It is shown that the frequency range of magnetometers with variometers based on vicalloy and samarium–cobalt will be bounded from above by frequencies of 1.6 and 6.4 Hz, respectively, at a threshold sensitivity of about 1 pT. These ratios of the frequency and threshold sensitivity for the given magnetic materials are probably limited for quartz variometers with an optoelectronic angle transducer.