This research investigates the plastic hinge length in lightly reinforced rectangular walls typically found in regions of low-to-moderate seismicity. Poor performance has been exhibited by lightly reinforced concrete walls in past earthquake events. A series of finite element analyses have been carried out which demonstrate that if the longitudinal reinforcement ratio in the wall is below a certain threshold value, there will not be sufficient reinforcement to cause secondary cracking, and instead fracture of the longitudinal reinforcement at a single crack could occur. A plastic hinge length equation has been derived based on the results from the numerical simulations.
Shear lag effects can significantly reduce the moment capacity of nonrectangular reinforced concrete walls. Although this phenomenon is recognized as an important component in the analysis and design of buildings, it is generally not well understood by practicing engineers. Furthermore, a paucity of experimental studies exists that have focused on the seismic performance of reinforced concrete C-shaped walls and virtually no studies that have investigated the shear lag effects for these types of walls. This research investigates shear lag effects in reinforced concrete C-shaped walls using an extensive number of finite element modeling results. The numerical analyses are conducted using VecTor3 version 1.1, a state-of-the-art finite element modeling program, to estimate the vertical strain distributions across the web and flanges of the wall. The results show that shear lag effects are significant and sometimes prominent in C-shaped walls, particularly for the wall sections perpendicular to the loading direction. An expression is derived to estimate the effective width of C-shaped walls and for the different loading directions. Moment-curvature analyses are conducted to illustrate how practicing engineers can implement the effective width method for future analyses and designs.
29 March 2018 in Journal of Earthquake Engineering
This research investigates the equivalent plastic hinge length of reinforced concrete C-shaped walls with reinforcement detailing typically found in low-to-moderate seismic regions. Reinforced concrete walls in these regions commonly have low amounts of longitudinal reinforcement and unconfined boundary regions, which have been shown to perform poorly in recent earthquake events. A series of state-of-the-art finite element analyses are undertaken to find the longitudinal strain distributions of low-rise, mid-rise, and high-rise C-shaped walls. The results of the equivalent plastic hinge lengths from the numerical investigation are shown to compare poorly to the predictions from some of the equations that currently exist in the literature. Subsequently, expressions are derived for the equivalent plastic hinge length for these types of walls and for the different modes of bending. The expressions derived from this research intend to improve the displacement capacity for these types of walls when using plastic hinge analyses.
1 September 2020 in Journal of Structural Engineering
Reinforced concrete (RC) U-shaped walls are a popular construction choice, commonly used to resist the lateral loads from wind and earthquakes. In many buildings, the center of stiffness of a floor is eccentric from the center of mass and the building will therefore undergo some twist. Often, U-shaped walls contribute significantly to the torsional stiffness of the building and the analysis of the structure therefore requires an estimate of the torsional stiffness. This research investigates the dependency of the torsional stiffness of U-shaped walls on the translational displacement demands using experimental evidence and advanced numerical models. The experimental results show that the torsional stiffness decreases with increasing translational displacement. Furthermore, the numerical and experimental results indicate that the torsional stiffness degrades at a similar rate as the translational stiffness of the walls. The rotational stiffness of the wall is smaller when it is centered than when it is subjected to a translation. This effect is attributed to the longitudinal stresses throughout the cross section that are already present due to the imposed flexural displacement. In particular, the compression zone resulting from the translational displacement imposed on the wall stiffens the wall with regard to the twisting. As a result, the effective torsional stiffness increases with increasing axial load ratio. Current codes do not provide reduction factors for the torsional stiffness, but the results show that the reduction factors for the shear stiffness can serve as estimate, albeit they do not capture the dependence on the axial load ratio.