The depletion of oil reserves and concerns about the environmental impact of the use and incorrect disposal of mineral lubricants have been promoting the development of bio-based lubricants. In this study, biolubricants obtained from fatty acids of castor oil were synthesized by esterification (>wt.%93), epoxidation (>wt.%92), and oxirane ring opening reactions using water (>wt.%92) or 2-ethylhexanol (>wt.%94) as nucleophilic agents. The frictional characteristics of the synthesized samples were obtained through tribological tests performed in a four-ball tester and compared with a commercial mineral oil. The sample obtained through oxirane ring opening with water showed the best frictional performance (FC = 0.0699 ± 0.0007) among the prepared samples, with equivalent wear rate (WSD = 281.2 ± 5.54 μm) and ca. 20% lower friction coefficient when compared to the commercial mineral oil, indicating its great potential for replacing mineral fossil oils.
Pipe conveyors provide sustainable solutions for environmentally sensitive or topographically complex powdered and bulk-solid handling processes; however, belt rotation is among the most critical failure modes of these equipment, influencing engineering, operational, and maintenance activities throughout the conveyors’ lifecycles. Position changes in the overlap are mechanical responses to uneven contact forces between the vulcanizing rubber belt and the idler rolls, owing to the highly nonlinear process of the belt folding from a trough to a tubular shape, and no method for quantifying the belt’s stability is currently available. In this study, we analyzed the failure mode of belt rotation and proposed a linearized model of an overlap stability index to evaluate the resilience of the overlap position through a case study of a short-flight curved pipe conveyor. Our proposal considers an interference model between the simulated torque of a curved flight in a pipe conveyor and the calculated torque of its equivalent straight flight by using kernel-smoothed density functions. It is adapted to incorporate adjustment factors for the filling degree based on simulations, the effect of the overlap in the forming force of the belt, the remaining useful life of the belt, and the coefficients of friction between the belt back cover and the idler rolls due to adhesion and hysteresis. An application was developed to calculate the belt’s rotational holding torque and rotary moment by processing real operational data, simulated contact forces, and the relevant equipment parameters. This analysis identified the reduced transverse bending stiffness and increased belt tension forces as the root causes for position changes with a loss of contact in the upper idler rolls of curved flights 10, 13, 15–16, and 17. The contributing factors included spots of augmented contact forces during the initial stages of the belt lifespan in curved flights 15–16, which presented unstable conditions due to increased opening forces, with an OSI of 0.8657. Furthermore, we proposed corrective and preventive action plans, an optimized replacement interval for the belt, and recommendations for design changes according to the relevant standards.
12 January 2022 in Journal of the Brazilian Society of Mechanical Sciences and Engineering