Microalgae produce a wide range of lipid compounds of potential commercial interest. Total lipid extraction performed by conventional extraction methods, relying on the chloroform-methanol solvent system are too laborious and time consuming for screening large numbers of samples. In this study, three previous extraction methods devised by Folch et al. (1957), Bligh and Dyer (1959) and Selstam and Öquist (1985) were compared and a faster single-step procedure was developed for extraction of total lipids from green microalgae. In the single-step procedure, 8 ml of a 2∶1 chloroform-methanol (v/v) mixture was added to fresh or frozen microalgal paste or pulverized dry algal biomass contained in a glass centrifuge tube. The biomass was manually suspended by vigorously shaking the tube for a few seconds and 2 ml of a 0.73% NaCl water solution was added. Phase separation was facilitated by 2 min of centrifugation at 350 g and the lower phase was recovered for analysis. An uncharacterized microalgal polyculture and the green microalgae Scenedesmus dimorphus, Selenastrum minutum, and Chlorella protothecoides were subjected to the different extraction methods and various techniques of biomass homogenization. The less labour intensive single-step procedure presented here allowed simultaneous recovery of total lipid extracts from multiple samples of green microalgae with quantitative yields and fatty acid profiles comparable to those of the previous methods. While the single-step procedure is highly correlated in lipid extractability (r² = 0.985) to the previous method of Folch et al. (1957), it allowed at least five times higher sample throughput.

The purpose of this study was to investigate whether pharmaceutical pollutants in urban wastewater can be reduced during algal cultivation. A mixed population of wild freshwater green algal species was grown on urban wastewater influent in a 650 L photobioreactor under natural light and with the addition of flue gases. Removal efficiencies were very high (>90 %), moderate (50–90 %), low (10–50 %), and very low or non-quantifiable (<10 %) for 9, 14, 11, and 18 pharmaceuticals, respectively, over a 7-day period. High reduction was found in the following pharmaceuticals: the beta-blockers atenolol, bispropol, and metoprolol; the antibiotic clarithromycine; the antidepressant bupropion; the muscle relaxant atracurium; hypertension drugs diltiazem and terbutaline used to relive the symptoms of asthma. Regression analysis did not detect any relationship between the reduction in pharmaceutical contents and light intensity reaching the water surface of the algal culture. However, the reduction was positively correlated with light intensity inside the culture and stronger when data collected during the night were excluded. Algae cultivation can remove partially or totally pharmaceutical pollutants from urban wastewater, and this opens up new possibilities for treating urban wastewater.

Microalgal-based wastewater treatment and CO2 sequestration from flue gases with subsequent biomass production represent a low-cost, eco-friendly, and effective procedure of removing nutrients and other pollutants from wastewater and assists in the decrease of greenhouse gas emissions. Thus, it supports a circular economy model. This is based on the ability of microalgae to utilise inorganic nutrients, mainly nitrogen and phosphorous, as well as organic and inorganic carbon, for their growth, and simultaneously reduce these substances in the water. However, the production of microalgae biomass under outdoor cultivation is dependent on several abiotic and biotic factors, which impact its profitability and sustainability. Thus, this study's goal was to evaluate the factors affecting the production of microalgae biomass on pilot-scale open raceway ponds under Northern Sweden's summer conditions with the help of a mathematical model. For this purpose, a microalgae consortium and a monoculture of Chlorella vulgaris were used to inoculate outdoor open raceway ponds. In line with the literature, higher biomass concentrations and nutrient removals were observed in ponds inoculated with the microalgae consortium. Our model, based on Droop's concept of macronutrient quotas inside the cell, corresponded well to the experimental data and, thus, can successfully be applied to predict biomass production, nitrogen uptake and storage, and dissolved oxygen production in microalgae consortia.

Algae are without doubt the most productive photosynthetic organisms on Earth; they are highly efficient in converting CO₂ and nutrients into biomass. These abilities can be exploited by culturing microalgae from wastewater and flue gases for effective wastewater reclamation. Algae are known to remove nitrogen and phosphorus as well as several organic contaminants including pharmaceuticals from wastewater. Biomass production can even be enhanced by the addition of CO₂ originating from flue gases. The algal biomass can then be used as a raw material to produce bioenergy; depending on its composition, various types of biofuels such as biodiesel, biogas, bioethanol, biobutanol or biohydrogen can be obtained. However, algal biomass generated in wastewater and flue gases also contains contaminants which, if not degraded, will end up in the ashes. In this review, the current knowledge on algal biomass production in wastewater and flue gases is summarized; special focus is given to the algal capacity to remove contaminants from wastewater and flue gases, and the consequences when converting this biomass into different types of biofuels.