Suman Saha

Dr. Suman Saha


Research Focus & Metrics

Academic Career Length

37Years (1990-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
31 December 2022 in International Journal of Mechanical Sciences
Verified
Journal Article
Closed access
SSSuman Saha
Suman Saha
Sankha DebSankha Deb
Sankha Deb
PBPartha Pratim Bandyopadhyay
Partha Pratim Bandyopadhyay

1 November 2020 in Journal of Materials Processing Technology
Verified
Journal Article
Closed access
SSSuman Saha
Suman Saha
SDSankha Deb
Sankha Deb
PBPartha Pratim Bandyopadhyay
Partha Pratim Bandyopadhyay

3 March 2022 in International Journal of Mechanical Sciences
Verified
Journal Article
Closed access
SSSuman Saha
Suman Saha
Sankha DebSankha Deb
Sankha Deb
PBPartha Pratim Bandyopadhyay
Partha Pratim Bandyopadhyay

1 January 2020 in Materials Today: Proceedings
Verified
Journal Article
Closed access
AKAbhishek Kumar
Abhishek Kumar
SSSuman Saha
Suman Saha
CKC.S. Kumar
C.S. Kumar
ANA.K. Nath
A.K. Nath

4 March 2021 in SN Applied Sciences
Verified
Journal Article
Open access
PDF file
SSSuman Saha
Suman Saha
BPBashab Chandra Paul
Bashab Chandra Paul
Santanu DasSantanu Das
Santanu Das
Activated tungsten inert gas (A-TIG) welding is one variant of conventional TIG welding where a thin layer of suitable activating flux is deposited on the parent components prior to constituting the arc in order to harness enhanced penetration. Despite several benefits, industries are still reluctant in overwhelmingly using this new variant. This article attempts to highlight the productivity benefits in employing A-TIG welding either together with or superseding TIG welding during butt joining of 10-mm-thick AISI-316L austenitic stainless steel components. Initially, three single-component fluxes (Cr2O3, Fe2O3, and SiO2) are tested in forehand welding technique under varying currents but with straight polarity. Filler rod having similar metallurgical composition is also delivered during homogeneous welding. The extent of capability of each of the three fluxes is analysed by comparing the weld bead geometrical parameters (penetration, puddle width, and reinforcement) with the same obtained in conventional TIG welding under similar set of parameters. While Fe2O3 and SiO2 fluxes are found capable in enhancing penetration and reducing puddle width and heat affected zone, Cr2O3 flux failed to exhibit better performance. The article further demonstrates the time saving that can be obtained by adopting flux-assisted TIG for joining 10-mm-thick plates. When joining from both the faces is allowed, about 70% less time is desired if a combination of A-TIG and TIG is employed rather than using only TIG welding. If joining from only one face is allowed, then also usage of flux can reduce welding time by 33%.

30 August 2020 in Journal of Welding and Joining
Verified
Journal Article
Open access
PDF file
SSSuman Saha
Suman Saha
Santanu DasSantanu Das
Santanu Das