To explore the potential for further enhancing the gas mixing uniformity of natural gas (NG) engines, this paper identifies turbulent kinetic energy (TKE), which has an essential impact on gas mixing, as the entry point of the research. After establishing a computational fluid dynamics (CFD) model for NG engines’ direct injection and mixing processes, the inlet pressure is selected as the experimental variable to investigate the influence of TKE on gas mixing uniformity. In particular, by proposing the theoretical concept of the core mixing stage, the numerical variation rule between the best mixture concentration region (BMCR) percentage and the mean turbulent kinetic energy (MTKE) of the core mixing stage is analyzed under certain injection timing conditions. The results indicate that, with identical intake pressures, an advanced gas injection timing elevates the total turbulence kinetic energy (TTKE) during the core mixing stage, thereby amplifying the uniformity of the gas mixture at the ignition. In specific scenarios, as the intake pressure increases, the decreasing trend in the BMCR proportion closely resembles the diminishing trend in the MTKE during the core mixing stage. Scrutinizing the variation trend in either parameter allows for an approximate prediction of the variation trend in the other parameter. When the intake pressure is gradually raised from the naturally aspirated state, the adequacy of the gas jet development is progressively reduced by the increasing back pressure in the cylinder.

Natural gas has emerged as one of the preferred alternative fuels for vehicles owing to its advantages of abundant reserves, cleaner combustion and lower cost. At present, the gas supply methods for natural-gas engines are mainly port fuel injection (PFI) and direct injection (DI). The transient injection characteristics of a gas fuel injection device, as the terminal executive component of the PFI or DI mode, will directly affect the key performance of a gas fuel engine. Therefore, gas fuel injection devices have been selected as the research object of this paper, with a focus on the transient injection process. To explore the impacts of valve vibration amplitude, period, frequency and velocity on transient injection characteristics, one transient computational fluid dynamics (CFD) model for gas fuel injection devices was established. The findings thereof demonstrated that there is a linear relationship between the instantaneous mass flow rate and instantaneous lift during the vibration process. However, this relationship is somewhat impacted when the valve speed is high enough. A shorter valve vibration period tends to preclude a shorter period of flow-hysteresis fluctuation. The near-field pressure fluctuation at the throat of an injection device, caused by valve vibration, initiates flow fluctuation.