Helicobacter pylori prevalence is elevated in German submarine crews and in United States Navy (USN) surface fleet personnel, but H. pylori prevalence in USN submariners was unknown. The goal of the study was to determine the prevalence of H. pylori in the crews of USN nuclear submarines compared to other military personnel and to the general US population. The presence of H. pylori IgG antibodies was determined in serum samples using a commercial ELISA. Only 47 out of 451 submariners (9·4%) were H. pylori positive, which is similar to that of the US general population with a similar level of education. In contrast, H. pylori prevalence is significantly higher in US Army recruits (26%), USN surface fleet personnel (25%), and German diesel submariners (38%). These data demonstrate that submarine service (and by inference activity requiring isolation and close contact, per se) is not a risk factor for H. pylori infection.
This study aims to evaluate the tribological performance of commercial PVD coatings in alleviating material transfer under unlubricated contact in the hot forming of aluminum alloy. The commercial PVD coatings included AlCrN, TiAlN, and Arc-DLC coatings, deposited on the forming tool surface. The warm and hot upsetting sliding test (WHUST) was used as a friction test in this study to reproduce the severe contact conditions from the hot forming process of AA6082-T6 aluminum alloy. The WHUST was performed at 300 °C, 400 °C, and 500 °C to investigate the effect of temperature on the tribological performance of each coating. The results found that the AlCrN and TiAlN coatings exhibited similar performance. They dominated the initial aluminum transfer by adhesive bonding. In contrast, the Arc-DLC coating mainly caused the initial aluminum transfer by mechanical plowing due to its lower chemical affinity to the aluminum alloy. In addition, the tribological performance of each coating highly depended on the temperature. Higher temperatures resulted in both stronger intermetallic bonding at the interface and lower yield strength of the aluminum alloy. These behaviors led to the variations in the coefficient of friction, the 3D topography and the SEM morphology along the wear track of the specimen, and the thickness of the adhered aluminum layer on the coating surface. In comparison, the Arc-DLC coating provided better tribological performance in mitigating the aluminum transfer than the others.