Wood saw dust is being considerably used in reinforcing polymer both from a scientific and a commercial point of view over the last decades. In this study, three different types of wood saw dusts were treated with 10% NaOH solution separately. Both chemically treated and untreated wood saw dust particles reinforced polymer matrix composites were prepared and their tensile strengths and water absorption behaviour were studied. In order to know the water absorption behaviour, both chemically treated and untreated wood saw dust reinforced polymer matrix composites were weathered in water at ambient temperature for different time periods. Experimental results showed that the tensile strength of the composites substantially increases due to chemical treatment of the wood particles. After calculation of water uptake, plot of percentage of water absorption versus weathering period was obtained. It has been revealed that chemical treatment of the reinforcing wood particles increases the water absorption of the composites. Results also indicated that water absorption of the composites increases with increasing percentage of wood particles and weathering period. SEM micrograph of the composites exhibited large cavity and air bubble on the tensile fracture surfaces of the composites. The underlying reasons related to the experimentally observed tensile and water absorption behaviour of the developed composites have been discussed in this paper
Detailed description and exploitation of materials in nanoscale have become an obvious part of polymer-based composites with the speedy progression of nanotechnology. This review will focus on some of the nanocharacterization techniques that are most frequently used in current research of composite structures with an emphasis on the interface zone of natural fiber and polymer matrix. The fiber-polymer interface is a transition region, which extends nanometers to micrometers over which the mechanical and physical properties change from the bulk properties of fiber to the bulk properties of the polymer. Therefore, a better understanding of interfacial properties and characteristics will be helpful in estimating the ultimate properties of fiber-reinforced polymer composites. A number of case studies related to interface and its impact on the macroscale performance of the composites from the published literature are discussed.
Printed circuit boards (PCBs) from antiquated electronic goods were processed by a pyrometallurgical route to produce and separate alloy and slag phases. The process involved initial size reduction of PCBs, followed by pyrolysis at 500 °C for 6 h and finally smelting of the solid materials in an electric furnace. A preliminary smelting test was performed at 1600 °C to estimate the composition of the slag generated. In later kilogram-scale smelting experiments, B2O3 flux was added along with CaO and SiO2 to decrease the liquidus temperature required to smelt the PCBs. The level of fluxing was adapted from earlier phase equilibria studies of the CaO-Al2O3-SiO2-B2O3 slag system. Results showed that the flux decreased the melting temperature and assisted the recovery of most valuable metals within the alloy phase at 1350 °C smelting temperature. The alloy phase recovered 99.8% of Cu, 99% of Sn, and 100% of precious metals (Au, Ag, Pt). A fluxing strategy for smelting high Al2O3 containing e-waste PCBs was proposed based on the experimental findings of this research.