Summary: 1. Researchers frequently take repeated measurements of individuals in a sample with the goal of quantifying the proportion of the total variation that can be attributed to variation among individuals vs. variation among measurements within individuals. The proportion of the variation attributed to variation among individuals is known as repeatability and is most frequently estimated as the intraclass correlation coefficient (ICC). The goal of our study is to provide guidelines for determining the sample size (number of individuals and number of measurements per individual) required to accurately estimate the ICC.2. We report a range of ICCs from the literature and estimate 95% confidence intervals for these estimates. We introduce a predictive equation derived by Bonett (2002), and we test the assumptions of this equation through simulation. Finally, we create an R statistical package for the planning of experiments and estimation of ICCs.3. Repeatability estimates were reported in 1·5% of the articles published in the journals surveyed. Repeatabilities tended to be highest when the ICC was used to estimate measurement error and lowest when it was used to estimate repeatability of behavioural and physiological traits. Few authors report confidence intervals, but our estimated 95% confidence intervals for published ICCs generally indicated a low level of precision associated with these estimates. This survey demonstrates the need for a protocol to estimate repeatability.4. Analysis of the predictions from Bonett’s equation over a range of sample sizes, expected repeatabilities and desired confidence interval widths yields both analytical and intuitive guidelines for designing experiments to estimate repeatability. However, we find a tendency for the confidence interval to be underestimated by the equation when ICCs are high and overestimated when ICCs and the number of measurements per individual are low.5. The sample size to use when estimating repeatability is a question pitting investigator effort against expected precision of the estimate. We offer guidelines that apply over a wide variety of ecological and evolutionary studies estimating repeatability, measurement error or heritability. Additionally, we provide the R package, icc, to facilitate analyses and determine the most economic use of resources when planning experiments to estimate repeatability.
Summary: 1. The Non‐Additive InVerses (nadiv) R software package contains functions to create and use non‐additive genetic relationship matrices in the animal model of quantitative genetics.2. This study discusses the concepts relevant to non‐additive genetic effects and introduces the package.3. nadiv includes functions to create the inverse of the dominance and epistatic relatedness matrices from a pedigree, which are required for estimating these genetic variances in an animal model. The study focuses on three widely used software programs in ecology and in evolutionary biology (ASReml, MCMCglmm and WOMBAT) and how nadiv can be used in conjunction with each. Simple tutorials are provided in the Supporting Information.
2 November 2018 in Annual Review of Ecology, Evolution, and Systematics
The rate of evolution of population mean fitness informs how selection acting in contemporary populations can counteract environmental change and genetic degradation (mutation, gene flow, drift, recombination). This rate influences population increases (e.g., range expansion), population stability (e.g., cryptic eco-evolutionary dynamics), and population recovery (i.e., evolutionary rescue). We review approaches for estimating such rates, especially in wild populations. We then review empirical estimates derived from two approaches: mutation accumulation (MA) and additive genetic variance in fitness (IAw). MA studies inform how selection counters genetic degradation arising from deleterious mutations, typically generating estimates of <1% per generation. IAw studies provide an integrated prediction of proportional change per generation, nearly always generating estimates of <20% and, more typically, <10%. Overall, considerable, but not unlimited, evolutionary potential exists in populations facing detrimental environmental or genetic change. However, further studies with diverse methods and species are required for more robust and general insights.
Replicated selection experiments provide a powerful way to study how “multiple adaptive solutions” may lead to differences in the quantitative–genetic architecture of selected traits and whether this may translate into differences in the timing at which evolutionary limits are reached. We analyze data from 31 generations (n = 17,988) of selection on voluntary wheel running in house mice. The rate of initial response, timing of selection limit, and height of the plateau varied significantly between sexes and among the four selected lines. Analyses of litter size and realized selection differentials seem to rule out counterposing natural selection as a cause of the selection limits. Animal-model analyses showed that although the additive genetic variance was significantly lower in selected than control lines, both before and after the limits, the decrease was not sufficient to explain the limits. Moreover, directional selection promoted a negative covariance between additive and maternal genetic variance over the first 10 generations. These results stress the importance of replication in selection studies of higher-level traits and highlight the fact that long-term predictions of response to selection are not necessarily expected to be linear because of the variable effects of selection on additive genetic variance and maternal effects.
22 November 2015 in Proceedings Of The Royal Society B-Biological Sciences
Given the pace at which human-induced environmental changes occur, a pressing challenge is to determine the speed with which selection can drive evolutionary change. A key determinant of adaptive response to multivariate phenotypic selection is the additive genetic variance–covariance matrix (G). Yet knowledge ofGin a population experiencing new or altered selection is not sufficient to predict selection response becauseGitself evolves in ways that are poorly understood. We experimentally evaluated changes inGwhen closely related behavioural traits experience continuous directional selection. We applied the genetic covariance tensor approach to a large dataset (n= 17 328 individuals) from a replicated, 31-generation artificial selection experiment that bred mice for voluntary wheel running on days 5 and 6 of a 6-day test. Selection on this subset ofGinduced proportional changes across the matrix for all 6 days of running behaviour within the first four generations. The changes inGinduced by selection resulted in a fourfold slower-than-predicted rate of response to selection. Thus, selection exacerbated constraints withinGand limited future adaptive response, a phenomenon that could have profound consequences for populations facing rapid environmental change.
Summary: Quantifying and predicting microevolutionary responses to environmental change requires unbiased estimation of quantitative genetic parameters in wild populations. ‘Animal models’, which utilize pedigree data to separate genetic and environmental effects on phenotypes, provide powerful means to estimate key parameters and have revolutionized quantitative genetic analyses of wild populations. However, pedigrees collected in wild populations commonly contain many individuals with unknown parents. When unknown parents are non‐randomly associated with genetic values for focal traits, animal model parameter estimates can be severely biased. Yet, such bias has not previously been highlighted and statistical methods designed to minimize such biases have not been implemented in evolutionary ecology. We first illustrate how the occurrence of non‐random unknown parents in population pedigrees can substantially bias animal model predictions of breeding values and estimates of additive genetic variance, and create spurious temporal trends in predicted breeding values in the absence of local selection. We then introduce ‘genetic group’ methods, which were developed in agricultural science, and explain how these methods can minimize bias in quantitative genetic parameter estimates stemming from genetic heterogeneity among individuals with unknown parents. We summarize the conceptual foundations of genetic group animal models and provide extensive, step‐by‐step tutorials that demonstrate how to fit such models in a variety of software programs. Furthermore, we provide new functions in r that extend current software capabilities and provide a standardized approach across software programs to implement genetic group methods. Beyond simply alleviating bias, genetic group animal models can directly estimate new parameters pertaining to key biological processes. We discuss one such example, where genetic group methods potentially allow the microevolutionary consequences of local selection to be distinguished from effects of immigration and resulting gene flow. We highlight some remaining limitations of genetic group models and discuss opportunities for further development and application in evolutionary ecology. We suggest that genetic group methods should no longer be overlooked by evolutionary ecologists, but should become standard components of the toolkit for animal model analyses of wild population data sets.