For decades, the benefits of utilizing hollow fiber bioreactors for continuous cell culture to produce monoclonal antibodies have been widely recognized. However, the suitability of this technology for laboratories or centers with limited resources and expertise seeking to expand their production capacity is uncertain, mainly due to unknown cost-effectiveness. In this study, a hollow fiber bioreactor with a 4.7-mL culture volume was used to culture a hybridoma clone producing immunoglobulin G antibody specific to hemoglobin F (HbF). The antibody reached a maximum concentration of 1.22 g/L and totaled 21 mg over a 44-day culture period. This preliminary production data was used to estimate the cost of consumables required for using the hollow fiber bioreactor to produce 130 mg of monoclonal antibodies, which was found to be THB35.8k (£880). The cost was slightly more expensive than batch cultivation in typical culture dishes, which ranged from THB27.8 to 30.2k (£680 to 740). Despite the advantages in terms of reduced hands-on time, shorter production duration, and highly concentrated products, the primary challenges associated with using hollow fiber bioreactors were the cost and availability of the cartridges.

We propose a minimal model defining the relationship between glucose and insulin with the added influence of food intakes. The constructed model consists of a system of 3 nonlinear ordinary differential equations (ODEs). The solutions of our model for both normal and diabetic subjects are compared with a minimal model and a maximal model representing the same relationship. We found that the outputs of our model are similar to those from the minimal and maximal models for both normal and diabetic subjects; the are 0.9997 and 0.9922, respectively, when compared with the minimal model, and are 0.9995 and 0.9940, respectively, when compared with the maximal model. Moreover, the relative errors between solutions are at most 0.9035% and as low as on average when compared with the minimal model for normal subjects and at most 1.331% and as low as 0.1159% on average for diabetic subjects. The discrepancy between our model and the maximal model are at most 1.590% and 5.453% for normal and diabetic subjects, respectively, with a relative error averaging 0.2138% and 0.9002% for normal and diabetic subjects, respectively.

Drilling is a solid material removal process that makes use of a spinning cutting tool to create a circular cross-sectional hole. During drilling, it is importa Drilling is a solid material removal process that makes use of a spinning cutting tool to create a circular cross-sectional hole. During drilling, it is importa