In order to improve the prediction accuracy, this paper proposes a short-term power load forecasting method based on the improved exponential smoothing grey model. It firstly determines the main factor affecting the power load using the grey correlation analysis. It then conducts power load forecasting using the improved multivariable grey model. The improved prediction model firstly carries out the smoothing processing of the original power load data using the first exponential smoothing method. Secondly, the grey prediction model with an optimized background value is established using the smoothed sequence which agrees with the exponential trend. Finally, the inverse exponential smoothing method is employed to restore the predicted value. The first exponential smoothing model uses the 0.618 method to search for the optimal smooth coefficient. The prediction model can take the effects of the influencing factors on the power load into consideration. The simulated results show that the proposed prediction algorithm has a satisfactory prediction effect and meets the requirements of short-term power load forecasting. This research not only further improves the accuracy and reliability of short-term power load forecasting but also extends the application scope of the grey prediction model and shortens the search interval.
In this article, the power generation of a concentrated space solar power station (SSPS) is enhanced by current-injected total-cross-tied (TCT-CI) photovoltaic (PV) array. First, a mathematical model of the TCT-CI–connected PV array is established. Second, PV arrays with several common topologies and TCT-CI topology are simulated and analyzed using MATLAB/Simulink. At last, comparative experiments are conducted for TCT and TCT-CI–connected PV arrays under the condition of non-uniform light intensity distribution. The results of the above indicate the following: 1) TCT-CI–connected PV arrays reduce the difficulty of MPPT in concentrated SSPS, 2) TCT-CI–connected PV arrays increase the power generated in concentrated SSPS, and 3) TCT-CI–connected PV arrays are applicable for concentrated SSPS.
In the face of the increasing depletion of non-renewable energy sources and increasingly serious environmental problems, the development of green and environmentally friendly renewable energy sources cannot be delayed. Because of the far-reaching development potential of solar energy, solar power has become an important research object for power development. The available solar energy in space is several times greater than that on Earth. Solar energy from space can be collected by a space solar power station (SSPS) and transmitted to the ground by wireless power transfer. In the full-chain ground-based validation system of SSPS-OMEGA, the spherical concentrator is used, and the light intensity distribution on the solar receiver is non-uniform. The non-uniform light intensity makes the output current of each photovoltaic (PV) cell on the solar receiver greatly different, and causes power losses, known as the mismatch problem. This paper proposes a simple, efficient and easy-to-implement method to optimize the structure of PV arrays to reduce the effect of non-uniform light on the output performance of each PV cell, which is beneficial to the topology of PV arrays and also effectively improves the layout rate. Then, a differential power processing (DPP) converter with a simple structure and easy control is designed to further deal with the power mismatch problem between series-connected PV modules. Finally, a simulation circuit model and a physical hardware model of the differential power processing PV system are built and used in the full-chain ground-based validation system of SSPS-OMEGA. The results demonstrate that the influence of non-uniform lighting on PV cells is effectively reduced, the output power of PV modules connected in series under non-uniform light distribution is substantially increased, and the photoelectric conversion efficiency is significantly improved.