This paper describes results and analysis of experimental testing of entire and partial compression strength and stiffness parallel to the grain of solid timber (Japanese cedar). To investigate the spreading effects, the size effect of strength and stiffness, and the mechanism of the damage zone located close to the loading plates, tests on 90 specimens were performed. As a result, it was observed that damage zones existed near the loading plates. The observed spreading effects in the compression parallel to the grain were very small which justifies neglecting them regarding strength and stiffness. Although a presence of a size effect of the compression strength parallel to the grain of glulam specimens with knots was reported, the compression strength parallel to the grain of solid wood specimens without knots does not have a size effect. The height and width of the cross-section of the specimens have an influence on the damage zones and, hence, on the effective modulus of elasticity of the full height of the specimens. The compression strength has a correlation with the density of the timber and the width of the annual rings.
This paper describes results and analysis of experiment of compression behavior parallel to grain of glulam (Norway Spruce, Japanese cedar, and Japanese cypress), especially in damage zones near loading plates and joints. To investigate the influence factors of physical properties and the mechanism of the damage zone near the loading plates or the joints, compression tests on 90 specimens and surface-measurement tests on 48 specimens were performed. As a result, it was observed that damage zones existed near the loading plates and the joints. The lengths of the damage zone of wood–wood joints are larger than that of wood–steel joints. The length of the damage zone was independent of the load and the height of the specimens. However, the length of the damage zone and its scatter increase as the width of the cross-section increases, as does the roughness on the contact surface. It was considered that the cause of the damage zone is the roughness on the contact surface and the length of the damage zone depends on the roughness on the contact surface. Therefore, the length of the damage zone depends on the processing accuracy on the contact surface and has an increasing trend as the contact-surface area increases. There was the size effect of the height of the specimens on the compressive strength because of knots.
17 November 2021 in European Journal of Wood and Wood Products
The compressive behavior parallel to the grain is an essential parameter for the designing of multistoried and large timber buildings. However, the application of a compressive force parallel to the grain results in significant deformations near the end grain, which is referred to as the damage zone. Therefore, this study elucidates the mechanism of the damage zone and proposed a methodology to evaluate the properties of the damage zone. The cause of the damage zone was attributed to an uneven contact surface. As the contact surface shape remained non-flat even after reaching 28% of the predicted maximum load, the initial stiffness of compression parallel to the grain necessitated an assessment based on the influence of the damage zone. The Young’s modulus of the damage zone was approximately 2% of that of the middle zone and an evaluation method for the damage zone length was proposed using the strongest link model. The Young’s modulus and damage zone length evaluation methods were used to evaluate the stiffness of the specimens when compressed parallel to the grain. The proposed method could adequately evaluate the experimental values.
Three-dimensional elastoplastic finite element (FE) analysis models considering a damage zone and cleavage were developed, including plastic behavior of embedment tests parallel and perpendicular to the grain at ambient and high temperatures, in order to study the embedment behavior of timber. In a numerical analysis of compression tests to define material properties of timber, the post-yield behavior of the X-axis in the axial direction was larger than the test values when the post-yield slope of the test result were set to the plastic modulus. The reason was that the stress on the Y-axis and Z-axis increased after the yield point; thus, the equivalent yield stress decreased. In the numerical analysis of the embedment tests, the effect of the damage zone must be considered in the analytical models because the initial stiffness of the numerical results in compression parallel to the grain was considerably higher than that of the test results when the damage zone was not considered. In the numerical analysis of the embedment tests in compression perpendicular to the grain, the two models reproduced the stiffness and behavior after the yield point of the test results. The model that considered cleaving showed the stress distribution after cleavage.