Background Tail docking is common practice in the sheep industry to prevent soiling of the breech and flystrike. To ensure optimal healing after tail docking and reduce the risk of arthritis, perineal cancers and prolapses, it is recommended to dock tails equivalent to the length of the vulva. However, recent studies have found that some tails are docked too short (24–86 per cent). Methods To address this issue, this study aimed to identify key drivers behind tail docking length decisions. Two focus groups, phone (n=30) and online surveys (n=21) were conducted in regional Victoria, Australia to examine farmer knowledge of and attitudes towards appropriate lamb tail length and barriers to best practice. The focus group data were analysed qualitatively, and the surveys were analysed qualitatively and quantitatively. Results In total, 57 per cent of farmers were classed as docking tails short. Short tail docking appeared to be influenced by unawareness of the recommended length and docking at a length that shearers approve of. Other potential factors included lack of knowledge of negative health consequences associated with short tails, importance placed on dag and flystrike prevention, and impracticality of measuring where to dock. Conclusion Addressing these factors in future education and intervention programmes may improve tail docking practice and sheep welfare.
Docking sheep tails is a long-standing practice that, when done at the recommended length, reduces the risk of flystrike. The recommended length is to cover the vulva of ewes and to a similar length in males. This length is often equated to three coccygeal joints left intact, and there are many other ways the recommended length is described by researchers, industry, and government. This study compared the observer consistency and retest consistency using three different tail length measurement methods: vulva cover assessment, length (mm), and joint palpation. The tails of 51 yearling and 48 weaner Merino ewes were assessed by two observers. Length and vulva cover assessment methods provided the most reliable results, and joint palpation was the least reliable method of tail measurement. In the sample, tails that covered the vulva of yearlings and weaners measured 57.6 mm (n = 14) and 63.7 mm (n = 30) on average, respectively, and contained two coccygeal joints (more than two coccygeal vertebrae). Tails that did not cover the vulva of yearlings and weaners measured 41.3 mm (n = 36) and 52.8 mm (n = 17) on average, respectively, and had less than two coccygeal joints. The two most reliable methods enable valid comparison to the best practice recommendations.
Context: In Australia, it is a common practice to dock sheep tails, to reduce breech soiling and flystrike. According to research, for docking to provide the optimal benefit, tails should be left at a length that covers the vulva in ewes and to an equivalent length in males. Docking tails shorter than recommended increases the risk of perineal cancers, arthritis and prolapse. Research indicates that some producers dock tails shorter than recommended, up to 57% in surveys and up to 86% in on-farm data. Aims: This study aimed to ascertain the current tail docking length, practices, knowledge and attitudes of Australian sheep producers. Methods: A national survey was conducted using online, hardcopy and computer-assisted telephone interview (CATI) modes of delivery (n = 547). Key results: Fifty-seven percent (205/360) of online and hardcopy survey participants chose short tail images to represent their practice, where the vulva was exposed. Although 88% (135/154) of CATI participants described their sheep tail lengths to be covering the vulva, participants equated the length to leaving two tail joints (40%, 54/134) and/or 50 mm (29%, 39/134), both of which have been previously found to be too short to cover the vulva. There was a high awareness of the recommended length (75.7%, 408/539) and 60% (234/390) of participants described it accurately. Significant associations were identified between choosing the short tail image and (1) describing the recommended length to be shorter than it is (P < 0.01), (2) being a producer in South Australia (P < 0.05), and (3) practicing mulesing (P < 0.01). Tail docking is important for producers to reduce flystrike, but docking at their chosen length held more importance than following the recommendation. Participants tended to agree that shearers preferred short tails. Docking tails with a hot knife or rubber rings were the most common methods used. Conclusions: These results indicated that short tail docking remains a sheep-welfare issue for Australian sheep, and that a knowledge–practice gap exists for some producers. Implications: Future research in the space of tail length could address the identified knowledge–practice gap, attitudes, and individual barriers to benefit sheep welfare and the industry.