Graphene oxide and chitosan composite material using as a high-efficiency and low-cost granular adsorbent for methylene blue removal was fabricated via self-assembling method. The effects of pH value, contact time, initial concentration, adsorbent dose, temperature, and recyclic stability on the adsorption performance of methylene blue in aqueous solution were investigated in detail. Desorption process with the effects of solvents, contact time, and temperature were also conducted carefully in this study. The adsorption kinetics and adsorption isotherm of dye adsorption process showed that dye adsorption process was fitted to the pseudo-second-order kinetic model and the Freundlich adsorption isotherm, indicating a physical adsorption process with multilayer adsorption. The intra-particle diffusion model indicated that the dye adsorption by the granular adsorbent was strongly happened during the first 4 h. The thermodynamic study showed that the adsorption was a spontaneous and exothermic process and dye ions were condensed onto the surface of adsorbent. The maximum adsorption capacity of dye on the granular adsorbent was calculated as 951.35 mg/g and the adsorbent could maintain its adsorption performance after six cycles. In general, this study provided an efficient, cost-effective, and recyclable the granular adsorbent for dye separation from aqueous solution.

This study presents the process of extracting lignin from sugarcane bagasse collected in the Mekong Delta, Vietnam by the alkali method. NaOH has been used as an effective, environmentally friendly chemical to enhance the extraction process. The obtained lignin was applied for methylene blue (MB) and hexavalent chromium (Cr(VI)) removal. Factors influencing lignin extraction and adsorption processes of MB and Cr(VI) were investigated, showcasing the sustainable reusability of lignin extracted from sugarcane bagasse. Lignin characterization was also carried out by scanning electron microscopy (SEM), Fourier transform infrared spectroscopy (FT-IR) and thermogravimetric analysis (TGA) techniques. The results showed that the extracted lignin content reached 38.61% under optimal conditions (NaOH concentration of 10%, reaction temperature of 90 °C and reaction time of 90 min). The adsorption efficiency and capacity of lignin reached 90.90% and 9.09 mg g⁻¹ for MB and 80.10% and 28.04 mg g⁻¹ for Cr(VI), respectively, under optimum adsorption conditions (pH, adsorption time, initial methylene blue concentration, and used lignin content). The adsorption process obeyed Langmuir adsorption and was principally physical adsorption. These findings prove sugarcane bagasse based lignin as a cheap and efficient adsorbent for MB and Cr(VI) removal, which contributes to the utilization of the abundant agricultural by-product for wastewater treatment.