In this paper the potentiality of impact avalanche transit time (IMPATT) devices based on different semiconductor materials such as GaAs, Si, InP, 4H-SiC and Wurtzite-GaN (Wz-GaN) has been explored for operation at terahertz frequencies. Drift–diffusion model is used to design double-drift region (DDR) IMPATTs based on different materials at millimeter-wave (mm-wave) and terahertz (THz) frequencies. The performance limitations of these devices are studied from the avalanche response times at different mm-wave and THz frequencies. Results show that the upper cut-off frequency limits of GaAs and Si DDR IMPATTs are 220 GHz and 0.5 THz, respectively, whereas the same for InP and 4H-SiC DDR IMPATTs is 1.0 THz. Wz-GaN DDR IMPATTs are found to be excellent candidate for generation of RF power at THz frequencies of the order of 5.0 THz with appreciable DC to RF conversion efficiency. Further, it is observed that up to 1.0 THz, 4H-SiC DDR IMPATTs excel Wz-GaN DDR IMPATTs as regards their RF power outputs. Thus, the wide bandgap semiconductors such as Wz-GaN and 4H-SiC are highly suitable materials for DDR IMPATTs at both mm-wave and THz frequency ranges.
Potentiality of Impact Avalanche Transit Time (IMPATT) devices based on different semiconductor materials such as InP, 4H-SiC, and Wurtzite-GaN (Wz-GaN) has been explored for operation at terahertz (THz) frequencies. Drift-diffusion model is used to design double-drift region (DDR) IMPATTs based on above mentioned materials at different millimeter-wave (mm-wave) and THz frequencies and the upper cut-off frequency limits of those devices are obtained from the avalanche response times at those mm-wave and THz frequencies. Results show that the upper cut-off frequency limits of both InP and 4H-SiC DDR IMPATTs are 1.0 THz; whereas, the same is 5.0 THz in Wz-GaN DDR IMPATTs. The Wz-GaN DDR IMPATTs emerge as the most suitable devices for generation of THz frequencies due to their small avalanche response time, high DC to RF conversion ratio, and sufficiently high RF power output at THz frequencies. But, it is observed that up to 1.0 THz, 4H-SiC DDR IMPATTs excel Wz-GaN DDR IMPATTs due to their higher output power densities. Thus, the wide bandgap semiconductors such as Wz-GaN and 4H-SiC are highly suitable materials for DDR IMPATTs at both mm-wave and THz frequency ranges.
15 June 2013 in Journal of Computational Electronics
Large-signal (L-S) characterization of double-drift region (DDR) impact avalanche transit time (IMPATT) devices based on silicon designed to operate at different millimeter-wave (mm-wave) and terahertz (THz) frequencies up to 0.5 THz is carried out in this paper using an L-S simulation method developed by the authors based on non-sinusoidal voltage excitation (NSVE) model. L-S simulation results show that the device is capable of delivering peak RF power of 657.64 mW with 8.25% conversion efficiency at 94 GHz for 50% voltage modulation; whereas RF power output and efficiency reduce to 89.61 mW and 2.22% respectively at 0.5 THz for same voltage modulation. Effect of parasitic series resistance on the L-S properties of DDR Si IMPATTs is also investigated, which shows that the decrease in RF power output and conversion efficiency of the device due to series resistance is more pronounced at higher frequencies especially at the THz regime. The NSVE L-S simulation results are compared with well established double-iterative field maximum (DEFM) small-signal (S-S) simulation results and finally both are compared with the experimental results. The comparative study shows that the proposed NSVE L-S simulation results are in closer agreement with experimental results as compared to those of DEFM S-S simulation.