The hydrations of Na+ and K+ were investigated by means of Monte Carlo simulations with refined ab initio based potentials. These interaction potentials include intramolecular relaxation, polarizability and many-body nonadditive effects. Care was taken to ensure proper convergence of the MC runs and that the statistical samples were large enough. As a result, agreement was attained with all experimental data available for the hydration of the ions. The water molecules in the first hydration shell were found to have the same intramolecular geometries and dipole moments as those of the bulk. Furthermore, their dipoles were not aligned to the electric field produced by the ion, but quite tilted. The hydration number for the sodium was found to be 5 or 6 water molecules, whereas the potassium’s hydration number had a probability distribution ranging from 5 to 10. From an analysis of the energetic contributions of each hydration shell to the total enthalpy of hydration we propose that the hydrated ions have a distinct behavior. Sodium has a stronger interaction with its first hydration shell than potassium, giving the latter a more flexible structure.
22 December 2000 in The Journal of Chemical Physics
In this work we present a new proposal to model intermolecular interactions and use it for water molecules. The parameters of the model were fitted to reproduce the single molecule’s electrostatic properties, a sample of 352 points in a refined ab initio single molecule deformation potential energy surface (PES), and the theoretical limit of the dimerization energy, −20.8 kJ/mol. The model was able to reproduce a sample of 180 additional points in the single molecule deformation PES, and 736 points in a pair-interaction surface computed at the level with the counterpoise correction. Though the model reproduced the diagonal of the polarizability tensor, it could account for only 60% of the three-body nonadditive contributions to the interaction energies in 174 trimers computed at the level with full counterpoise correction, but reproduced the four-body nonadditivities in 34 tetramers computed at the same level as the trimers. The model’s predictions of the structures, energies, and dipoles of small clusters resulted in good agreement with experimental data and high quality ab initio calculations. The model also reproduced the second virial coefficient of steam at various temperatures, and the structure and thermodynamical properties of liquid water. We found that the short-range water–water interactions had a critical influence on the proper performance of the model. We also found that a model based on the proper intermolecular interactions requires the inclusion of intramolecular flexibility to be adequate.
29 April 2009 in The Journal of Physical Chemistry B
Using a simple model it is shown that the cost of constraining a hydrated potassium ion inside a narrow nanopore is smaller than the cost of constraining the smaller hydrated sodium ion. The former allows for a greater distortion of its hydration shell and can therefore maintain a better coordination. We propose that in this way the larger ion can go through narrow pores more easily. This is relevant to the molecular basis of ion selective nanopores and since this mechanism does not depend on the molecular details of the pore, it could also operate in all sorts of nanotubes, from biological to synthetic.
15 September 2011 in Physical Chemistry Chemical Physics
A four-site rigid water model is presented, whose parameters are fitted to reproduce the experimental static dielectric constant at 298 K, the maximum density of liquid water and the equation of state at low pressures. The model has a positive charge on each of the three atomic nuclei and a negative charge located at the bisector of the HOH bending angle. This charge distribution allows increasing the molecular dipole moment relative to four-site models with only three charges and improves the liquid dielectric constant at different temperatures. Several other properties of the liquid and of ice Ih resulting from numerical simulations with the model are in good agreement with experimental values over a wide range of temperatures and pressures. Moreover, the model yields the minimum density of supercooled water at 190 K and the minimum thermal compressibility at 310 K, close to the experimental values. A discussion is presented on the structural changes of liquid water in the supercooled region where the derivative of density with respect to temperature is a maximum.