The construction of a navigation constellation with inter-satellite links (ISLs) has become one of the important development trends for new-generation global navigation satellite systems (GNSSs), and ISLs currently realize navigation and communication functions through separate low-rate omnidirectional telemetry, tracking, command and high-rate data service channels, respectively. If the above two functions are integrated into one channel, this will result in simplification of the onboard equipment, improvement of the electromagnetic compatibility, power consumption reduction and frequency resources savings, and we speculate that autonomous navigation will be achieved by ISLs with navigation and communication fusion. In this paper, a system capable of simultaneous high-data rate communication transmission and precision ranging is investigated, and a specific scheme is introduced by combining continuous phase modulation (CPM) and a pseudonoise (PN) ranging code denoted as CPM+PN. The chip pulse is one of the key factors to design the ranging code, which not only affects the ranging performance but also influences the properties of the CPM+PN scheme, such as its spectral characteristics, communication reliability, and acquisition time. To consider the above performance indexes, a new chip pulse based on a normally distributed wave is proposed. Theoretical analysis and simulation results show that compared to square-wave and half-sine wave cases, the normally distributed wave attains great advantages in the ranging accuracy and communication reliability, which become more notable with reasonable selection of the energy distribution index. Moreover, the proposed chip pulse achieves a similar acquisition time as the traditional wave. As a result, the normally distributed wave can be used as a better alternative to the ranging chip pulse for the CPM+PN waveform.
30 August 2022 in IEEE Transactions on Aerospace and Electronic Systems
Ranging and communication are the two main functions of inter-satellite link (ISL). The integration of these two functions and transmission of them on the same link can simplify the onboard equipment, reduce power consumption, save frequency resources, and integrate the ground station resources to reduce the complexity of the management system. In view of this, the regenerated pseudo-noise (PN) ranging signal and continuous phase modulation (CPM) communication signal are combined at the phase level, and an integrated signal model of ranging communication based on CPM+PN is proposed in this paper. To improve the accuracy of intersatellite ranging, an adaptive parameter selection algorithm is proposed in this paper, which can adaptively select the ranging signal weighting factor according to the current channel state. The simulation results show that the adaptive parameter selection algorithm can greatly improve the ranging accuracy on the premise of ensuring the reliability of communication.
This letter introduces the combination and separation of the waveforms in the simultaneous transmission of a communication signal and ranging signal. A novel iterative cancellation receiver relating to threshold detection and an iterative loop is proposed to counteract the mutual interference caused by waveform separation. The separated communication signal and ranging signal serve as the prior condition for each other to achieve the virtuous cycle, that is to say the lower communication bit error rate (BER) makes the separated ranging signal more accurate, while the smaller ranging phase offset allows it to have a weaker interference on the communication signal. The BER and ranging jitter results corroborated by Monte Carlo simulation show that the proposed iterative cancellation receiver exhibits higher communication reliability and ranging accuracy compared to the traditional receiver. Moreover, the performance gain is more prominent with the decrease of preset threshold or the increase of ranging modulation index.
The multi-spectral radiation temperature measurement technology faces problems of uncertain target emissivity models and large temperature measurement errors. This paper proposes a multi-spectral radiation temperature measurement method based on optimized identification of emissivity models. Firstly, an emissivity model is established. Secondly, the particle swarm optimization algorithm is used to train the least squares support vector machine. Then, this algorithm is used to identify the target emissivity model, which has stronger applicability and accuracy compared to existing identification methods of emissivity models. Finally, a multi-spectral target equation is constructed and the particle swarm algorithm is used to invert the target temperature. Simulation experimental results show that this method can obtain more accurate emissivity models and temperature inversion, improving the generality and stability of the multi-spectral radiation temperature measurement method. Simulation and existing experimental comparisons show that the proposed multi-spectral radiation temperature measurement method based on optimized identification of emissivity models performs well in the identification of target emissivity models and temperature measurement, providing an effective solution for practical temperature measurement.