The Global Navigation Satellite System (GNSS)-based passive bistatic radar (PBR) which uses the GNSS signal as the illuminators of opportunity is studied for moving target detection (MTD). GNSS-based PBR has many advantages due to the removal of the transmitting device; however, its fundamental limitation is the low power density of the GNSS signal. Therefore, the integration time should be sufficiently long to obtain a promising maximum detectable range. On the other hand, the integration time is limited by the range migration and Doppler migration of the echo caused by target motion. In this letter, a novel MTD algorithm is proposed for the GNSS-based PBR, by employing a modified radon Fourier transform (MRFT) to achieve the required long-time integration for moving targets. The MRFT integrates the echo energy via joint searching of range, Doppler, and Doppler rate of the target, which can handle not only the range migration but also the Doppler migration problems, and significantly improves the signal-to-noise ratio (SNR) of the echo signal. An experiment using the GPS L5 signal as the illumination source is conducted and a moving car is successfully detected by the proposed algorithm, although significant range migration and Doppler migration are present due to variation of its speed.

Synthetic Aperture Radar (SAR) is a well-established and powerful imaging technique for acquiring high-spatial-resolution images of the Earth’s surface. With the development of beam steering techniques, sliding spotlight and staring spotlight modes have been employed to support high-spatial-resolution applications. In addition to this strengthened high-spatial-resolution and wide-swath capability, high-temporal-resolution (short repeat-observation interval) represents a key capability for numerous applications. However, conventional SAR systems are limited in that the same patch can only be illuminated for several seconds within a single pass. This paper considers a novel high-squint-angle system intended to acquire high-spatial-resolution spaceborne SAR images with repeat-observation intervals varying from tens of seconds to several minutes within a single pass. However, an exponentially increased range cell migration would arise and lead to a conflict between the receive window and ‘blind ranges’. An efficient data acquisition technique for high-temporal-resolution, high-spatial-resolution and high-squint-angle spaceborne SAR, in which the pulse repetition frequency (PRF) is continuously varied according to the changing slant range, is presented in this paper. This technique allows echo data to remain in the receive window instead of conflicting with the transmitted pulse or nadir echo. Considering the precision of hardware, a compromise and practical strategy is also proposed. Furthermore, a detailed performance analysis of range ambiguities is provided with respect to parameters of TerraSAR-X. For strong point-like targets, the range ambiguity of this technique would be better than that of uniform PRF technique. For this innovative technique, a resampling strategy and modified imaging algorithm have been developed to handle the non-uniformly sampled echo data. Simulations are performed to validate the efficiency of the proposed technique and the associated imaging algorithm.

Global Navigation Satellite System Reflectometry (GNSS-R) based Bi-static Synthetic Aperture Radar (BSAR) is becoming more and more important in remote sensing, given its low power, low mass, low cost, and real-time global coverage capability. Due to its complex configuration, the imaging for GNSS-R BSAR is usually based on the Back-Projection Algorithm (BPA), which is very time consuming. In this paper, an efficient and general imaging algorithm for GNSS-R BSAR is presented. A Two Step Range Cell Migration (TSRCM) correction is firstly applied. The first step roughly compensates the RCM and Doppler phase caused by the motion of the transmitter, which simplifies the SAR data into the quasi-mono-static case. The second step removes the residual RCM caused by the motion of the receiver using the modified frequency scaling algorithm. Then, a cubic phase perturbation operation is introduced to equalize the Doppler frequency modulation rate along the same range cell. Finally, azimuth phase compensation and geometric correction are completed to obtain the focused SAR image. A simulation and experiment are conducted to demonstrate the feasibility of the proposed algorithm, showing that the proposed algorithm is more efficient than the BPA, without causing significant degradation in imaging quality.

The high-squint airborne Synthetic Aperture Radar (SAR) has the ability to detect the target area flexibly, and the detection swath is significantly increased compared with the side-looking SAR system. Therefore, it is of great significance to carry out research on high-precision imaging methods for high-squint airborne SAR. However, the high-squint SAR echoes have large Range Cell Migration (RCM), resulting in severe range–azimuth coupling and strong spatial variation. In this paper, a Modified Range Doppler Algorithm (MRDA) is proposed to cope with these effects introduced by the significant RCM in high-squint airborne SAR imaging. The bulk compensation preprocessing is first adopted to remove the considerable RCM and severe cross-coupling in a two-dimensional frequency domain. Then, Non-Linear Chirp Scaling (NLCS) in the range direction is utilized to equalize the range-variant chirp rate caused by the residual RCM and coupling and, therefore, the consistent range phase compensation can be fulfilled in range frequency domain. The modified correlation processing is executed to compensate the residual Doppler phase modulation, the residual RCM and the range-variant cubic phase modulation, which guarantees the characteristics of high efficiency and high precision. The simulations have demonstrated that the MRDA can focus the SAR echoes with large squint angles more effectively than the algorithms based on the Linear Range Walk Correction (LRWC) method.

Scanning synthetic aperture radar (ScanSAR) mode is widely used in Earth observation because of its capability of acquiring wide-swath images with moderate resolution. However, due to the operation mechanism of ScanSAR mode, the acquired images often suffer from the scalloping problem, resulting in significant deterioration of image quality. In this article, a novel scalloping suppression method is proposed for ScanSAR images based on the modified Kalman filter with preprocessing. First, an image model is built to analyze the effect caused by scalloping. Then, a modified Kalman filter is proposed to estimate the intensity of scalloping. However, if the scene is complicated or the scalloping effect is strong, the Kalman filter works with poor performance. Therefore, an innovative preprocessing operation is introduced, involving image segmentation and pixel value filling. Finally, the proposed method is verified by the GaoFen-3 (GF-3) and TerraSAR-X satellite images with different scenes. The results demonstrate that the proposed method can accommodate the complex scene well and achieve effective scalloping suppression.

Squint spaceborne Synthetic Aperture Radar (SAR) can significantly improve the ground observation performance of platform sensor through flexible beam pointing; however, it is still challenging for squint spaceborne sliding spotlight SAR data focusing since the significant Range Cell Migration (RCM) and Range Azimuth Coupling (RAC) caused by the squint angles. Whereas the Linear Range Walk Correction (LRWC) can deal with these problems, the traditional Chirp Scaling (CS) algorithm cannot adapt to the signal model after the LRWC operation, especially in the case of sliding spotlight mode. In this letter, a Hybrid CS Algorithm (HCSA), integrating the Modified CS (MCS) in range time domain with the Frequency CS (FCS) and Frequency Non-Linear CS (FNLCS) in azimuth frequency domain, is proposed for squint sliding spotlight SAR system. After LRWC and deramp operations, the Hybrid CS (HCS) based on the updated signal model is employed to fulfill whole scene focusing, which can equalize the Doppler Frequency Modulation Rate (DFMR) and handle the back-folding issue in azimuth time domain simultaneously. The geometric correction is then be applied to obtain the focused SAR image without LRWC geometry distortion. Simulation demonstrates that for the spaceborne SAR with 1.0m resolution in both range and azimuth directions, and a squint angle of 30°, the proposed HCSA can realize effective focusing within the full scene.