In this article, the model of a 5 kW small wind turbine blade is developed and improved. Emphasis has been placed on improving the blade’s efficiency and aerodynamics and selecting the most optimal material for the wind blade. The QBlade software was used to enhance the chord and twist. Also, a new finite element model was developed using the ANSYS software to analyze the structure and modal problems of the wind blade. The results presented the wind blade’s von Mises stresses and deformations using three different materials (Carbon/epoxy, E-Glass/epoxy, and braided composite). The modal analysis results presented the natural frequencies and mode shapes for each material. It was found, based on the results, that the maximum deflections of E-glass, braided composite and carbon fiber were 46.46 mm, 33.54 mm, and 18.29 mm, respectively.

Previous research indicates that the inclusion of nanosilica (NS) modifies the properties of the fresh and hardened state, compared to the traditional mineral additions. NS decreases the setting times of the cement mortar compared to silica fume (SF) and reduce of required water while improving the cohesion of the mixtures in the fresh state. Some authors estimate that the appropriate percentage of Nano-silica should be small (1 to 5% by weight) because of difficulties caused by agglomeration to particles during mixing, while others indicate that 10% by weight, if adjustments are made to the formulation to avoid an excess of self-drying and micro cracks that could impede strength. For this purpose, the present work aim to see the effect of the introduction mode of the nanosilica on the rheological and physic mechanical properties of cement mortars. In this study, NS was used either powdered with cement or in solution with the superplasticizer (Superplasticizer doped in nanosilica). Results show that the use of nanosilica powder (replacing cement on the one hand) has a negative influence on the rheological parameters and the rheological behavior of cementitious pastes. However, the introduction of nanosilica in solution in the superplasticizer (SP) was significantly improved the rheological parameters and the rheological behavior of cementitious pastes. Indeed, more the dosage of NS-doped SP increases more the shear stress and viscosities of the cementitious pastes become more fluid and manageable. A significant reduction of shear stress and plastic viscosity were observed that due to the increase in superplasticizer. A dosage of 1.5% NS-doped SP gave adequate fluidity and the shear rate was lower.

The work aim is to investigate the rheological and mechanical behavior of eco-friendly mortar made with marble powder. Marble have used as sand by total substitution of natural sand and as additional materials by partial substitution of cement. Firstly, rheological tests were carried out on the...